Customer Questions and Answers for Range Lp Gas Conversion Kit by Frigidaire

Hello Larry, you can tell the orifices apart by the size of the hole in each one. You have 4 different sizes so I have listed below where I show they should be positioned according to the parts list for your model. Hope this helps!
Right Front 316527509 Orifice 17K
Left Rear 316527511 Orifice 14K
Left Front / Center 316527500 Orifice 9.5K (2 used)
Right Rear 316527504 Orifice 5K

Hi Tony, I could not find an LP conversion kit for this model so I looked up the User Manual and Installation Instructions. It looks like this model was not designed to be converted to LP gas. It states in the instructions, "DO NOT attempt to convert this range to L.P. (Propane) Gas. This appliance is designed to operate with Natural Gas only." That may explain why a kit could not be found. Thanks!

Hello Ismael, you are correct. You need to order kit# GRLP3 for conversion to LP gas.

Hi Brenda, the model number given looks more like a serial number instead. Could you please send a valid model number and I can help you find the parts you need. Thanks!

Hello Kball. Yes, just remove the screws securing the burners and remove the burners from the top. Then you can access and remove the orifices from the unit without raising the top of the unit.

Hello Sally. Sorry, but you will need to contact the manufacture for the reason why there is no kit. We do not have that information available. Thank you.

Sally, the manufacturer does not offer a conversion kit for LP to NG. You will need to purchase the NG orifice 316237902. Thanks!

Hello Joe. First, make sure the kit was installed properly into the unit. If so, make sure you fliped the regulator from natural gas to LP gas.

Hello Gene,

These are right handed thread so counter-clockwise should remove them. Most are 7mm. They do tend to seize over time since the heat they are exposed to expands and contracts the metals so drastically. The only way this can be partially avoided is to apply some grease to the threads during the installation of the orifices. If you twisted one off,you will have to replace the ignitor/orifice assembly. If you try to drill and easy-out the old orifice, the assembly will have to be removed from the unit to get all of the metal slivers out since they will hamper the normal operation of the burner.

You can try to heat the ignitor assembly first as this will expand the metal and they will sometimes release. The trick to this is after the metal has been heated, use an ice cube, touching only the orifice. This causes the orifice to contract and if the ignitor assembly is hot, it is expanded. This will SOMETIMES do the trick.

Hello Timi! The LP Conversion kit GRLP3 will include the LP orifices for each burner, they will be different sizes. The kit will inlcude installation instructions for installation assistance. Thanks!