Tom July 09, 2012 for Model Number fggf3054mf What is the color of the orifice for the center oblong burner and there was only 1 purple for the large burner in the kit..what should I do?
1 Answer Hello Tom. The left front and the center both use the orifice marked Marked 89L for LP gas in the kit GRLP3. Read More...
Wally W. July 09, 2012 for Model Number fgfl77ase Converting from lp to natural gas, what parts will I need?
1 Answer Wally, you will need to replace the orifices. You will need one 316237901 and three 316237902. Flip the pin on the regulator back to NG. Thanks! Read More...
Katie July 05, 2012 for Model Number FGF354BGDF I have a frigidaire stove model # FGF354BGDF that I need to convert to lp/propane gas. Just wondering exactly which converter kit I need to buy for this stove? Thanks.
Bob June 08, 2012 for Model Number FFGF3015LBD I ordered Part AP4374168 And used GRLP3 out of the kit , 4 orifices on the top burners and they work fine , also converted the regular, it is the steel top type. On the oven I turned the spud down for LP and adjusted the air on it and I get a high flame that comes up into the oven. No matter where the air adjustment is it still gets a high flame inside the oven. Please help me out on this.
1 Answer Bob, It sounds like there's no LP pin inside the valve opening. You'll need to remove the orifice from the safety valve and check for the LP pin. ( the LP pin looks like a 3 point arrowhead, with a hole in the point), you'll need to cross reference the orifice to the LP kit and install the orifice. If the pin is there, you'll need to raise it using needle nose pliers and twisting, high enough for it to meet the Nat gas orifice when you turn it down. Thanks and Good Luck Read More...
Joel May 23, 2012 for Model Number plgc30s9eca Hello there. I would like to convert from nat gas to propane for my frigidaire gas range (model plgc30s9eca). From what I understand, the burners remain the same, and the jets get replaced. Is this the correct conversion kit, and does this kit include all four jets as well as the different jet sizes needed? Thanks, Joel
1 Answer Hello Joel! The LP conversion kit 318127425 comes with four LP orifices to convert your unit over to LP. This kit will also include the instructions to help with the conversion. These orifices are the only parts needed to make the conversion. Thanks! Read More...
Ledane S. April 09, 2012 for Model Number Figidaire FGGF3032MB Gallery Series Gas Range I would like to convert this to LP gas. I can't seem to find the Model # for this particular range. Which conversion kit should I use?
1 Answer LeDane, to convert model FGGF3032MB to LP you will need part number GRLP3. This kit comes with instructions. Thanks! Read More...
Norasit April 02, 2012 for Model Number BGGF3042KFN Hello I need to convert from LP to NG what parts would I need? Thank you.
1 Answer Hello Norasit! You will need to purchase one 17K burner orifice 316527509, one 5K burner orifice 316527504, one 12K burner orifice 316527502, and two 9.5K burner orifices 316527500. Flip the regulator cap back to NG. Thanks! Read More...
Marilyn April 01, 2012 for Model Number fgfl87dcg I am confuse on how many items and what areas need changed to convert from natural gas to lp
1 Answer Marilyn, The insruction booklet that comes in the conversion kit will be a bit more explicit but, You will need to replace the five, burner orifices on the top burnmers. You'll need a 7 MM nut driver, and in your case, each burner will have a different orifice, and you'll need to be specific. You may have to replace the bake and broil oven burner orifices, or at least adjust them with a 1/2 inch open end wrench. The Gas regulator 5304521339 Does not need to be replaced, but you will need to covert it to LP gas using a crescent wrench and or flatblade screwdriver. You will also need a small flat blade srewdriver to adjust the low flame setting on the top burner valves. Once you have the kit and the instruction sheet, you'll do fine. Thanks and Good Luck Read More...
Lorne January 18, 2012 for Model Number fgf366bcc Just wondering how much to adjust oven orifice and if there is any adjustment for the broiler?
1 Answer Hello Lorne. You will adjust the orifices with the flame lite, and adjust it until all yellow tips are gone from the flame, and it burns a true blue. Hope this helps. Read More...
Lorne January 13, 2012 for Model Number fgf366bcc I am converting my stove from lp back to natural gas, and would like to know what changes I need for my specific model? I have looked around your site without avail. and hope that I am not asking a redundant question. Thanks.
1 Answer Hello Lorne! You will need to order the original orifices. You will need a qty of three (3) of the 9.5k burner orifices 316237902 and one (1) 12k burner orifice 316237901. Thanks! Read More...