Don April 11, 2022 for Model Number LGGF3043KFR I broke the oven door switch on my Frigidaire gas oven. model #Lggf3043kfr Is there a video or directions how to replace this part? Thank you
1 Answer Don, Remove the burner grates, caps and heads. Once these are removed you will use a flat blade between the control panel and main top to release the spring clips that hold the main top in place. Once done with this, lift the main top and you should be able to take the door switch out by depressing the tabs that hold in and install the new one. Read More...
Scottyinstl February 03, 2020 for Model Number Kenmore 79074333315 How do I remove stove top in order to get to the oven light switch and replace it?
1 Answer Scott, If you remove the burner grates, the burner caps and burner heads you will be able to lift the main top and access the light switch. Read More...
Ty January 08, 2018 for Model Number 1977 Sears Country kitchen stove Used this switch to replace one with a broken plunger. Fit perfect but operated backwards. Is this switch normally 'off' when open? I think it is. If you agree, can you recommend a switch, same size, that is normally 'on' when open?
1 Answer Ty, The similar switch we could find is part number WP3196262 / WP3196262 The circuit is "open/off" when the plunger is pressed in, and is "closed/on" when the plunger is out/extended. Read More...
Brian December 20, 2017 for Model Number Frigidaire Range Model DGEF3041KFN I need to replace the oven light switch on the model listed. Do I have to remove the panel to get at it? Thank you
1 Answer Hello Brian, This switch 316445500 is located behind the front panel and is accessed by raising the main top and reaching down to it. The control panel does not need to be touched during this repair. Be sure to unplug the unit before accessing the switch since there is 120Vac on the switch and 240Vac under the main top. Read More...
Doug November 10, 2016 for Model Number 79079379400 Oven door switch replacement. Is assembly done from removing burning assembly and trays from top, or do you have to remove front door oven trim and inside wall.
1 Answer Doug, To replace the light switch you will want to remove the burners and lift the main top of the unit. Read More...
Jay K. February 02, 2015 for Model Number LGEF3045KFE Our Frigidaire model: LGEF3045KFE oven does not get hot. When it is set to 350°, it warms up forever but never gets to the desired temperature. Is this a sensor, thermostat, switch or element problem? Please let me know so I can get this fixed so that my "honey-do" list can have this taken off. Thanks
1 Answer Hello Jay, If the unit is operating properly on broil, the issue will be the bake relay on the control, or the element is burned out and shorted to ground. It is more possible for the control to be at fault. If the broil is not operating properly either, you should flip the breaker off and back on since one side of the breaker tripped will be trying to heat the 240Vac element with only 120Vac. There could also be a connection issue with the power supply at the junction box, (wire nuts), wall outlet, or terminal block, (where the cord connects to the appliance). Read More...
Merv December 03, 2014 for Model Number 790.92803010 Kenmore oven is taking over 3 hours to get up to 300 degrees. We changed oven probe and it did not help. Maybe it is only getting 110?
1 Answer Hello Merv. Check the bake element in the unit and see if it is good. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Richard November 20, 2014 for Model Number 790.78859602 Convection fan does not run. It may be the switch which is activated when the oven door closes. How do I change it?
1 Answer Hello Richard. You need to test for power to the fan motor during a convect bake cycle. If power is there the fan motor is bad. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Harry B October 04, 2013 for Model Number 790.7938 How do I access the switch on my Kenmore Elite Duel Fuel Range. # 790.7938 ? From the schematic it looks like its behind the side panel
1 Answer Hello Harry. Remove the top burners and raise the top to access and replace the switch on the unit. Read More...
Lanny C. June 30, 2013 for Model Number FGEF3077KWA Oven will not turn off after it has been turned on.
1 Answer Hello Lanny, This sounds like a relay on the control board (AP4433345) is sticking. Read More...