Steve C March 15, 2013 for Model Number TPX24PPDACC Original problem was water leaking (flooded floor) from water dispenser in freezer door. Ice maker worked fine. Order#3215050 changed out two different WR57X10022 water valve kits. Both stopped leak at dispenser door, but also stopped water to ice maker. I'm guessing after reading Q/A and talking with both Karen and Kevin that problem may lie with dispenser board. What do you suggest?? Original water valve may be fine or possible dual failure?? Sorry, forgot to add: 1) there is water from the house side to the water valve, normal flow and pressure. 2) there is no water at the base of the freezer door in the water line coupling 3) no buzzing sound at the icemaker 4) the ice maker corkscrew motor does not run with ice selected at the freezer door
1 Answer Steve, Based on the description it does sound like the control board WR55X129 for the dispenser has failed and would need to be replaced. Read More...
Neale January 04, 2013 for Model Number tps24bpcebs The white colored fitting on the john guess connector broke when removing the white plastic water supply tube from the refrigerators water valve, can I get just the white fitting that goes on the tube or do I have to buy the whole new water valve(wr57x10024)?
1 Answer Hello Neale. You will need to order a new water valve WR57X10024 to replace the fitting. Read More...
Larry B. February 24, 2012 for Model Number TFX28PPDABB How are the water lines removed (retainers released) at the valve assembly? What's the trick?
1 Answer Hello Larry. The connectors in question are called John Guess fittings. When you put a water line in you have to pull on it to seal the fitting. To remove a line from a John Guess fitting, You push the line hard into the fitting and hold the ring around the line against the valve assembly as you pull the water line out. The white, orange, and grey things on the illistration for WR57X10022 are the John Guess fittings. Hope this helps you! Read More...
Wes October 25, 2011 for Model Number TPX24PP How do I cycle the ice maker to see if there is power going to the water valve? If there is power getting to the water valve how will I know will it make a humming noise? Thanks, Wes
1 Answer Hello Wes. There is a test button on the original icemaker you press to cycle the icemaker. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Wes October 24, 2011 for Model Number TPX24PP I have a GE Profile side by side the ice maker just stopped working the other day. I do get water out of the door but water is not getting into the ice maker. Prior to the ice maker not working I did notice that sometimes the ice cubes were not solid but almost hollow. I read this could be caused by low water pressure, so I tested to see if the filter was plugged, it was, I replaced the filter and the water comes out strong but still no water gets to the ice maker. Is this a water valve problem or something else? Is ther a way to test the water valve? Also I already checked the water inlet tube it's not frozen. Any help would be appreciated.
1 Answer Hello Wes. Yes, based on the information you provided, it sounds like the water valve WR57X10022 is bad and will need to be replaced. Cycle the icemaker and see if there is power going to the water valve. If so, and no water comes in, replace the valve. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Sue April 03, 2011 for Model Number TPX24BPBGBB How do you disconnect the plastic water lines from the old valve?
1 Answer Hello Sue. The plastic connections the lines go into, push in and the lines will pull out. These are compression fittings. Hope this helps. Read More...
1 Answer Hello Vic. Part number WR57X10022 is the correct valve and brackett assembly for your model TPS24BPDABS. Hope this helps. Read More...
Jerry March 19, 2011 for Model Number tps24ppbgbs Is part number ap2071734 your number for GE part number WR57X10026?
1 Answer Hello Jerry! No, WR57X10022 does not match GE WR57X10026. For our matching part number to GE WR57X10026 order WR57X10026. Thanks! Read More...
1 Answer Yes, both valves and long bracket are included in this kit. For same valve kit with short bracket order WR57X10026. Please note, if the original wiring harness does not work you must order WR23X10108. Read More...