Greg July 11, 2011 for Model Number WHSE5240D1WW I believe this is the part I need to replace, but it could be the pressure switch. When we turn on the washer or when it does the rinse, the water just dribbles out (I have had to use a hose to fill it up!), but if I unplug the washer for a couple seconds and then plug it back in, the water flows normal for a few seconds then gets lower and lower? Once it is full it runs fine, but the amount of water that comes out has gradually gotten less and less until recently no water comes out.
1 Answer Greg, the issue would not be due to the control assembly, it could be due to weak water pressure, debris in the water supply lines or a fill valve problemWH13X10024, Thanks and good Luck. Read More...
Billy H. June 13, 2011 for Model Number WHRE5260E1WW (GE Washer) If this part is defective, will it cause the washer to just stop somewhere in the wash cycle?
1 Answer Hello Billy. Yes, if the control assembly WH12X10323 is defective, it can cause the machine to stop during the wash cycle. Hope this helps. Read More...