Customer Questions and Answers for Conversion Kit Asm by Ge

Steve, The Nat gas orifices aren't available as individual parts, you will need to order the orifice holder/tube assembly(s) to receive the Nat Gas orifices. the part numbers are: WB28K10289 / WB28K10289 Cntr, WB28K10424 / WB28K10424 R/F, WB28K10388 / WB28K10388 L/F, WB28K10389 / WB28K10389 L/R, WB28K10390 / WB28K10390 R/R. The oven bake and broil orifice hoods are adjustable, you'll need a 1/2 inch open end wrench to adjust the hoods up(counterclockwise) 2 1/2 to 3 revolutions, and "flip" the gas regulator cap back to the NAT setting. Check for gas leaks and fine tune the fuel air mixture on all the burners Until the flame is blue, and there is little to no yellow or white tips.

Tom, The washer would go on the pressure regulator. You have to remove the cover of the pressure regulator and flip the nut over to where the N is facing you not LP.

Ken, To change the unit back to natural gas you will need to get the orifice holders center WB28K10867, right front WB28K10424, left front WB28K10389, left rear WB28K10389, and right rear WB28K10390. For the oven you will need to loosen the orifice 1 1/2 to 2 turns and close the air shutter to about 3/4 of the way open. On the regulator flip the pin or cap from LP to NAT.

Richard, You will need parts WB28K10289, WB28K10424, WB28K10388, WB28K10389, WB28K10390 and find the pressure regulator and remove cap to flip screw around so that nat is facing you.

Hello John, you'll need to order the orifice holders for the unit as the manufacturer does not offer the orifices separate. For the center burner you'll need WB28K10289, right front WB28K10424, left front WB28K10388, left rear WB28K10389 and the right rear WB28K10390. The bake and broil orifices as well as the pressure regulator are adjustable, please refer to your installation instructions. Thanks!

Hello Patrick. You will need to order WB28K10562 for the conversion kit needed for the unit.