Jeff January 21, 2014 for Model Number jgb280den3www Stove was converted to lp gas on installation. Now customer has gotten natural gas. Kit was sent and 4 orifices on surface burners were changed. Does broler and bake orifice need to be changed or how are they adjusted?
1 Answer Jeff, The bake and broil element would be turned 1 1/2 to 2 turns loosened. You would open the air shutters about 3/4 of the way. Adjust as needed. Flip the regulator cap from LP to Nat. Read More...
Kathy January 14, 2014 for Model Number JGB280DEN3WW We need to convert from LP back to Natural Gas and we did not keep the original natural gas orifices that came with the GE stove. Is there a kit we can purchase that will have the Natural Gas parts in it?
1 Answer Hello Kathy, You will need to order part number WB28K10556. As per the product notes, this Is Nat To Lp Conversion Kit to go from Lp back to Natural gas. Read More...
Margaret October 28, 2013 for Model Number JGBP32AES3AG I have the part number to convert this free standing gas range to propane. Do these go on the burners or at the bottom of the stove.
1 Answer Hello Margret, These are the orifices for the surface burners. Be sure to match the sizes with the BTU of the burner it is installed into. Read More...
Wayne July 07, 2013 for Model Number RGB745WEA2WW I have a Hotpoint natural gas range that I would like to convert to propane. Model # is RGB745WEA2WW. Can you please tell me how and what conversion kit to purchase? Thanks.
1 Answer Wayne, you'll need to order conversion kit part number WB28K10043 to convert your appliance to LP. Flip the pin on the regulator and adjust the oven orifices. You will need to bottom the orifice out and come back up one and a half turns. Adjust the burner flame until it is blue. Thanks. Read More...
Mary April 04, 2013 for Model Number Hotpoint rgb 745 WEH5WN Is there a secret place where orifices are stored?
1 Answer Mary, you'll need to lift the cooktop up to gain access to the orifices. The orifices are in the middle of the brackets on the orifice holders. The conversion kit will come with further installation instructions. Thanks. Read More...
Dawn February 06, 2013 for Model Number Kenmore Gas Range model 790.7250* We have the conversion kit and there are 5 colored orifices. We are unsure of which ones go on which burner. The original orifices have already been removed. Where can I get this information?
F.S. May 08, 2012 for Model Number RGB745BEH6 WH Converting a free-standing 4-burner Hotpoint (GE) range from natural gas to propane. I found Item # AP3778747, GE mfg # AP4368229/conversion Kit # WB28K10556; Does each burner require a seperate kit, & does the oven require a kit as well? Thanks for your prompt attention.
1 Answer Hello! The conversion kit WB28K10556 comes with all parts needed to convert your appliance over to LP. You will only need one kit. Thanks! Read More...
Joyce W. January 26, 2012 for Model Number RGB746WEH1WW I have a hotpoint (ge) free standing range that is presently burning propane. I need to change it to natural gas. Please tell me if I need parts to do this. If I need parts what parts are they? And does anyone have a diagram of how this is to be done or do you have any referrals in the richmond, va area that are knowledgeable about the subject. I have tried quite a few plumbers and they all seem to be dumbfounded about the subject.
1 Answer Hi Joyce. Remove power and shut the gas supply off behind the unit. There are 3 -different colored coded top burner orifices. One nat' gas is part # W10613606 blue color. Another is part # WB28K10030 red color this is for the front rt and the lt.. Another is part # WB28K10029 1 07mm is for the small burner at the rt rear. and the last one is part # WB28K10022 medium size this orifice is for lt. front and r.r top burners. Then you loosen the bake and broil burner orifice hoods up 2-to-2-1/2 full turns. On the side of the safety valve is a lever to shut the gas off to the safety valve only. You also remove the gas regulator cap and invert the pin under the top so it says "nat" instead of "lp". Remember to adjust the air shutters on the lower bake and broil burner assy. Thank You. Read More...
Jo W. October 19, 2011 for Model Number RGB533DEP1BB I need to convert 5 stove top burners and the oven burner from ntaural gas to propane. Your service consultant gave me a part #, AP4368229 which she said was a conversion "kit". Which burner, how many burners does this service?
1 Answer Hello Jo. The conversion kit WB28K10556 converts all for burners on the top of the unit. You will need to flip the regulator and adjust the oven burners. Hope this helps. Read More...