Skip to Content
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Trusted Since 1999 Trusted Since 1999
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google

Customer Questions and Answers for Dual Bake Element by Ge

Best Seller
Manufacturer Part
4.89 (64)
By: Ge
Part Number: OEM11380725
Manufacturer Part Number: WB44T10048

This dual bake element restores even, reliable heat in your range or wall oven's bake cycle. Replace a burned-out or damaged element to recover proper preheat times and consistent cooking performance.

  • Produces heat during the Bake cycle to reach and maintain set temperature
  • Works with the companion element to promote even baking results
  • Replace if the oven won't heat, preheats slowly, or bakes unevenly
  • Signs of failure include blisters, breaks, or a section that won't energize

What's included: 1 dual bake heating element Install notes:

  • Disconnect power at the breaker before servicing; allow the oven to cool completely
  • Remove racks, take out mounting screws, and gently pull the element forward
  • Support and label wires to prevent them from retracting; transfer connections securely
  • Reinstall element so it doesn't contact the cavity; restore power and test Bake

More

Questions & Answers

For Ge Dual Bake Element (Part Number: OEM11380725)

Dick B. for Model Number JT930SK3SS

This unit is making a clicking noise. I have replaced WB27T10551 (per your suggestions) and the clicking has not stopped. I have narrowed down where the clicking is come from. Part # WB18T10326 (AP3883407). In the back of the unit there are 2 fans (1 on each side) with paddles that activate small switches which actiavte the relay. If I run the unit without the top cover, no clicking. If I replace the cover, clicking starts. If I lift one corner slightly in the rear, clicking stops. Do I have an airflow problem, switch problems or a relay issue? Thanks

Dick B. for Model Number JT930SK3SS

Replaced part WB27T10551 per your suggestion because the unit was clicking rapidly when in bake mode (and possibly slow heating). When the unit was out of the wall and the new part installed without door there was no clicking. Replaced unit into wall and secured to wall (still no door attached) the clicking started. I also ran into this same situation when I had the old part installed. Remove unit from wall, no door, no clicking when in bake mode. Reinstall unit, clicking again. Any ideas?

1 Answer

Dick,

It would be suggested to check the wiring of the unit to make sure you do not have any loose connections. This sounds like it would be more likely than anything.

Read More...
Dick B. for Model Number JT930SK3SS

When I turn my oven on (bake or broil) there is a clicking sound (every second) coming from the control panel (very annoying). When the oven door is opened I can see the oven light flickering with the same speed as the clicking. Any ideas as to what could be the problem? The oven and broiler work, although reports are that the oven does not heat up as fast as it once did. The lower element does not glow as red as the broil element. Very faint glow. Thanks

1 Answer

Dick,

This issue would be a relay on the control board that is clicking and causing the lights to flicker. The part that would be needed is the main power board part number WB27T10551.

Read More...

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro
Or ask a question by filling in the form

Share your thoughts with other customers

Ask a Question
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google