Charles S. P September 06, 2022 for Model Number LG Model LMV1683ST The microwave only runs for 8-10 seconds each time it is started.
1 Answer Charles, This issue will most likely be caused by a faulty thermostat or a control board. You will want to check the thermostats and if they are good then replace the control board. Read More...
Bob May 19, 2020 for Model Number jtpwoa1ww Does the part# ap320270 control both microwave and oven or is there a separate panel for each?
1 Answer Hello Bob, the touchpad/display panel WB36X10093 (no longer available) controls the microwave through the microwave control board WB27T10463, and the lower oven thru the lower oven board WB27T10088 (no longer available. Read More...
Aczman March 10, 2020 for Model Number J TP90B M2BB The oven portion works great. The microwave dose not work. When you open door the light flickers on and off. While it flickers you hear a clicking sound coming from behind the control panel. Display does not work and nothing happens when you press any of the buttons.
1 Answer Hello Aczman, this sounds like a low voltage supply problem to the microwave section or the microwave control board, access the rear of the control board and check for any loose wire connections and use a multimeter to check for 120v into the microwave control board. Read More...
John January 30, 2019 for Model Number JTP90SP3SS Microwave is not working, and no display on the panel. Tech says that control board is out and GE is no longer making the product. Do you all carry the control board?
Paul M December 17, 2018 for Model Number JTP85 Built in Oven w/ MW circa 1998 Hello, Both the oven heating element (at the bottom) and the broiler do not function. The heating elements do not heat up or turn red as if no electricity is running through them after setting a baking temperature or broiler setting. And, they both malfunctioned at the same time. The MW works fine along with the control switches (panel) embedded on the face of the MW. Thank you. Regards, Paul M.
1 Answer Paul, It would be recommended to test at the control board for 240 vac from the Bake or broil to the L2 and if there is not proper power then the control board would need to be replaced. Read More...
David M. November 29, 2017 for Model Number JTP85WOD1WW The time and temperature display on the lower oven window display are very dim.
1 Answer Hello David, The Oven control will require replacement or repair. Since the part is no longer available, you will need to contact a company such as Corecentric Solutions 866-737-2244/ corecentricsolutions.com and inquire if they support board WB27T10594. If so, they will be able to repair your board. Read More...
Pat C. February 03, 2013 GE spacemaker XL1400 microwave. It does not heat every time. When it does heat, it seems to work ok. Also, when I press power level it tells me power level cannot be changed at this time. Can you help me? Thank you.
1 Answer Hello Pat, This sounds like the relay on the control board has burned contacts that aren't making electrical contact every time. The control board should be changed. I usually include a part number but, with no model number listed, the specific part number cannot be looked up. The power level indicates the board has an issue also. Read More...
Rudy June 27, 2012 for Model Number jtp86bfbb Everything works but every 30 second there is a beep. Is it the control board causing the problem?
1 Answer Hello Rudy. Unplug the ribbon cable from the board and see if the beep continues. If so, replace the control board WB27T10463. If not replace the panel WB36T10652. Read More...
Bob S. November 20, 2011 for Model Number JTP86S0H5SS Microwave will not work. Numbers are flashing across cotrol panel . Clock is very dim on Oven control panel
1 Answer Hello Bob. Check and see if there is a power problem. If not, then you will need to replace both control boards WB18T10303 and WB27T10463. Hope this helps. Read More...