Brad D. April 08, 2011 for Model Number WPRB8050DWW I am ordering this part. How do I find information on how to access and replace the defective one?
1 Answer Brad, to replace the ATC sensor "The automatic temperature control feature is used to provide optimum wash water temperature. The ATCuses a water temperature sensor (thermistor) with a negative temperature coefficient (as temperature rises, resistance lowers), located in the top of the hose and water inlet to detect incoming water temperature. To access the assembly you will need to:"1. Remove 4 screws from the rear of the control panel. 2. Gently pull on each corner to unsnap the control panel from the sides of the unit. 3. Rotate the control panel forward approximately 1 inch and slide to the right to un1. Locate 2 spring clips between the top cover and front panel by aligning a putty knife with left or right edge of lid. 2. Insert the putty knife and push forward to release clips. 3. Rotate the front panel forward and lift off the bottom tabs. Note: Do not allow lid to swing open when cover/ lid assembly is removed. Damage may result.To remove the cover/lid assembly: 1. Remove the front panel and control panel. 2 Disconnect 2 wire clips and the lid lock harness from the electronic control board. 3. Remove 2 (1/4-in.) hex screws securing the front of the cover/lid assembly to the cabinet. 4. Remove the lid switch from the cover/lid assembly. 5. Pull the top cover toward you while lifting up the front edge to release the side catches and rear locking tabs. Remove the top cover." You will now have access to the water inlet and ATC sensor. Good Luck and Thanks. Read More...
1 Answer Hello Roy. This part controls the water temperature coming to the washer. Hope this helps. Read More...