Skip to Content
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Trusted Since 1999 Trusted Since 1999
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google

Customer Questions and Answers for Water Level Switch by Ge

Best Seller
Manufacturer Part
4.89 (64)
By: Ge
Part Number: OEM6137700
Manufacturer Part Number: WH12X10068

Questions & Answers

For Ge Water Level Switch (Part Number: OEM6137700)

1 Answer

David, A proper model number would've been helpful, But in most GE washers all the components you mentioned are located, accessed and serviced through the control panel. Remove power and water supply to the washer. Remove the four screws across the top of the console and roll the console down. Disconnect the air tube WH41X365 from the pressure switch and check for a closed circuit between the empty terminal and common terminals (usually terminal 6 and 7) or according to the wiring diagram. Blow into the end of the hose to make sure there are no twists, kinks or debris in the hose. Blow lightly into the spout on the switch and you should hear the switch "click" when it changes circuits. The water valve WH13X10024 has two solenoids each solenoid should have a resistance reading of 500 to 1000 ohms resistance when tested with a multi meter, with the wires disconnected. This isn't a 100% accurate test. The solenoids could give a proper reading, but the valve could still be faulty, depending on the complaint.

Read More...

1 Answer

Hello Ric. If you can stop the water from entering the machine by turning off the timer or unplugging the unit, you will need to look for a bad pressure hose or replace the pressure switch. If the only way to shut off the water is at the shut off for the water hoses, you will need to replace the water valve in the unit.

Read More...
Dawn for Model Number GTWN3000M1WS

When I set my washer to large or super, it will run the water, but it's draining at the same time and you end up with a small load of water instead of large or super. I'm sure my water bill is going to be outrageous because of this problem. Would it possibly be the water level part that might need to be replace. Already tried the shortening the hose that the water drains from but that didn't work either. Thanks for any help in this area. Dawn

1 Answer

Hello Dawn,
The drain hose must be at least as high as the main top of the machine or the water will gravity feed right down the drain. If the standpipe is too low, you will need to support the drain hose with a screw and a wire tie or the equivalent.

Read More...

1 Answer

Hello Sal. If you can stop the water from entering the machine by turning off the timer or unplugging the unit, you will need to look for a bad pressure hose or replace the pressure switch. If the only way to shut off the water is at the shut off for the water hoses, you will need to replace the water valve in the unit.

Read More...

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro
Or ask a question by filling in the form

Share your thoughts with other customers

Ask a Question
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google