Ge WH41X365 Pressure Switch Hose OEM Part

I replaced the water level switch and hose. After removing the hose, I found that it was clogged, and did not allow the water level to be sensed by the switch. A test after the replacement of the parts was successful. While filling the tub, the water shut off at the small, medium, and large levels as indicated by the switch.

We had two problems at the same time. The washer was occasionally overflowing especially on super loads, and also leaking out the bottom, which got worse really fast. The overflow problem we have had before when the pressure switch hose became plugged with gunk, but cleaning the hose didn' fix it this time. The leak could be seen just above the trans. housing at the drum, so we diagnosed a bad seal. Knowing that the bearing would have to be running with water in it we also ordered the bearing and tub bearing washer. Also knowing Murphy's law we ordered the hub nut, the hub washer, and the split ring. Turned out the hub washer was broken, which may have contributed to the seal failure. We reluctantly also purchased the spanner wrench, not knowing what size the nut was. Turned out to be helpful in the long run. All the parts came in a couple days in one box. My son and I completed the repair in about an hour. Pretty simple deal. We replaced the pressure switch and hose also and now all is well. The trans shaft is corrode in the seal area, which we helped a little with some 600 wet sanding, so we anticipate the seal leak may return, and if it does a new trans will be needed. The washer has been running for several days now (we do a lot of laundry!) and so far so good.

The washer worked fine on the small or large load but when placed on super load it would overfill. Replaced the pressure switch based on this sites recommendation and it worked like a charm. Took about 10 minutes for the whole job.

Relied on a U-tube video to walk me through the replacement of the pressure switch on my GE Washer. After viewing the video I decided that I could perform the repair. The video was easy to follow and made the repair relatively straight forward. I checked the internet and selected Appliance Pros based on price to order the parts from. The parts provided by Appliance Pros were received the next day after order was placed and were like for like OEM and were correct. The parts were wrapped in a GE bag. I was pleased with the ease of ordering the parts, the order service and the fast delivery provided by Appliance Pros and will definitely use them again. I saved a lot of money for performing the repair myself.

Replaced pressure switch, pressure switch hose, and water inlet valves. Repair took about 15 minutes. So far so good. No overflow of water since repair.