Tre B April 06, 2017 for Model Number LG WM0642HW I recently replaced the Drain Pump on my Washer Machine, instead of going through the top I unplugged the washers hot and cold water and power and laid it on its back and installed it through the bottom. once I put the machine back together in tested that the water drained, I ran a load of clothes and got a UE code, cleared it and it went on to spin, but what I noticed was that when the machine spins it seems to be a bit loose and there's a clicking sound when it does. would this possibly be due to the bracket in the back causing the sound and the UE error?
1 Answer Tre, The UE error code would most likely be caused by the bracket assembly which is part number 4811ER3001A. Read More...
Kimber March 10, 2017 for Model Number WM2077CW My machine stops at the 10 minute mark and will not perform the final spin. I ran diagnostics, no errors showed up, yet machine will not perform final spin. All I get is UE error code. Which part do I order for this model? Thank you
1 Answer Hello Kimber, This is most likely going to be caused by either a bad harness to the RPS. If not, the RPS 6501KW2002B is the next suspect. Read More...
Aarone February 07, 2017 for Model Number WM2277HW LG tromm Ive read a lot that says i need to replace the ball sensor (balance sensor) My washer gives a UE code when it goes into spin and shuts off. In diagnostic mode I get a bE code. Thats great but I cant find anything on your site that is called a ball or balance sensor. It it the same as AP4438319 the bracket assembly? If not what part is it? Thank you guys!!
1 Answer Aarone, The ball sensor for this unit will be the bracket assembly 4811ER3001A. Read More...
Jayson September 11, 2013 for Model Number WM1815CS How do you check to see if the load ball sensor is defective? Load stop mid cycle and shuts off completely? Replaced the rotor position sensor already and that was not the issue? Thinking by a few of your posts that the ball sensor could be bad?
1 Answer Hello Jayson. Rock it back and forth and as the ball rolls, the unit should open and close. Read More...
Brenda March 26, 2013 for Model Number WM1814CW I am replacing the assembly sensor for my washer but I cant find were the bracket is to replace the sensor. Please help me with were it is located on my washer.
1 Answer Hello Brenda. Unscrew the 4 screws from the back cover. Unscrew the single screw from the lower-right side of the cabinet. Disconnect the connector from PWB Harness. Remove the bracket assembly 4811ER3001A from the unit. Read More...
Becky July 25, 2012 for Model Number WM1812CW What is this sensor commonly known as?? What is its function??
1 Answer Hello Becky. 4811ER3001A is the vibration sensor and is used to detect off balance loads. Read More...
Robin October 25, 2011 for Model Number WM2677HCM Does this item (Bracket Assembly Part# AP4438319) include the Sensor Assembly Part# AP4440678 (Diagram A490 shows a dotted square for both parts)?
1 Answer Hello Robin. Yes, the bracket assembly 4811ER3001A includes the sensor and the bracket. Hope this helps. Read More...