Sarah January 29, 2019 for Model Number WT5070CW I have an LG top load WT5070CW. The coupler is cracked and yet I still can't get it off the shaft. Do I need to remove the inner tub and/or the whole clutch assembly to replace the coupling assembly? Thank you for any help.
1 Answer Sarah, the coupling assembly should have a few screws holding it in place so that the actuating arm engages properly. Once these screws are removed, the entire coupling and base should come right off. Read More...
Nancy July 08, 2018 for Model Number 796.29002000 The washer I have was gave to me and I was told it wont spin out anymore my father in law who works on washers and such told my husband that it needed a coupling is the part I would need.
Jeff February 09, 2018 for Model Number WT5070CW Hopefully I can make sense of this.. I am replacing the coupling assy. When the rotor is put back on and the coupler gears are lined up with it, the teeth end up not lining up to the part of the coupler assy that is screwed on. Is that ok/normal?
1 Answer Hello Jeff. The coupler will engage and disengage based on the cycle settings. It should work properly if installed correct onto the unit. If not, then the board may have an issue with the cycles. Thank you. Read More...