Ken July 09, 2020 for Model Number 796.41473210 Nothing happens when I push the power button. If I unplug the washer and plug it back in, it works for one load, but if I want to wash another, I have to unplug it again. Is it the main control board? Tom for Model Number 79641472210 ANSWER Tom, This issue does indicate that the main control board will be the issue. I have same problem can you please tell me the part # for the main control board for my model. Thanks
Scott June 24, 2020 for Model Number 79641473210 Hello, I have a Kenmore Elite washing machine, model #79641473210. It was running the other day and the power went out. After power was restored I unplugged the unit and let sit for 10 minutes. I now get intermittent PF errors. I'm thinking this is most likely the control board AP5977709. Can you think of any other reasons I would get the PF error? Thank you for your time!
1 Answer Scott, if there is a constant 120VAC going to the main control while a power failure error starts, the failure would certainly be in the main control EBR78263902. Read More...
Kirk October 23, 2019 for Model Number 796.414.7210 I tried doing a load and it would not drain. I vacuumed the water out then tried an express load and going through a rinse cycle and would not drain. I unplugged and plugged back in... still not draining.. help please
1 Answer Kirk, the coin catch filter will need to be inspected for any clogs as well as the drain pump being inspected. If there are no clogs then the voltage going to the drain pump will need to be tested. The voltage can be tested from the main control during a spin cycle at the blue two-wire connection. The connection will have a brown wire and a black wire and the brown wire would be tested to ground for 120VAC going to the drain pump. If there is not 120VAC when the unit is in spin and should be draining, then the main control EBR78263902 has failed. If there is 120VAC, then the drain pump 4681EA2001T has failed. Read More...
Joe February 04, 2018 for Model Number 796.41473210 I replaced the main control board to clear the power problem I had. However, now I get intermittent faults. PW (power fault) and LE (motor sensor fault) I have replaced the motor position sensor and checked wiring. These faults still happen, intermittently. No specific time. Could this be a bad control board problem?
1 Answer Joe, Based on what is occurring it would be recommended to check the wiring of the unit and if the wiring is good then this will likely be an issue with the main control board. Read More...
Tom April 07, 2017 for Model Number 79641472210 Nothing happens when I push the power button. If I unplug the washer and plug it back in, it works for one load, but if I want to wash another, I have to unplug it again. Is it the main control board?