Paul January 27, 2015 for Model Number LMX21981ST First had slow water from dispenser, so I changed filter, still slow, so I changed the valve with 2 inlets behind filter, when I turned water back on, had strong flow for 5 seconds, then the flow slowed to the way it was before......any ideas?.......thanks
1 Answer Paul, With the increase in pressure then dropping back down, this issue would most likely be caused by a bad water filter head which is part number 5230JA2003A. Read More...
Dan January 07, 2015 for Model Number LRSC26923TT I had the same problem as David with water flowing out of the filter head. I removed the filter and cover and noticed about a 1" diameter round insert with off-set flow holes that align with the water inlet and outlet openings when the filter is inserted and rotates this part into the proper alignment. I'm able to insert the part fully into my water filter head and align it by rotating with the filter, but the pressure of the water forces the part out of the filter head creating a leak. I don't see that insert in the water filter head images on this page. Is it a separate piece or will it be integrated if I order a new filter head? Thanks, Dan
1 Answer Dan, The part that you are inquiring about would be a part of the filter head assembly. The part number for the filter head 5230JA2003A. Read More...
Walter December 29, 2014 for Model Number LRSC26941ST Water will not dispense in the ice tray after dumping the ice. Water does dispense from the water dispenser in the door. So I assume the valve is working. What is the problem?
1 Answer Hello Walter, Since the water valve is a dual valve, the water valve 5221JA2006D is the most likely problem. There is a possibility of the contacts in the icemaker assembly 5989JA1005D being bad, but the valve is more likely. Read More...
Mike December 01, 2014 for Model Number LFX28978ST/00 What is the correct water filter part number for this model number LFX28978ST/00? I bought LG 5231JA2006A Refrigerator Water Filter and it is too big.
1 Answer Mike, the water filter listed for your model is part number AGF80300702. Thanks. Read More...
Wayne November 21, 2014 for Model Number LSC27950ST When trying to remove the water lines from my water cartridge head, I broke the plastic retainer rings that hold the tubes in, can I get replacements without having to buy the entire unit?
Darrell November 17, 2014 for Model Number 795.75193401 What are the reasons that why would I replace the water filter head?
1 Answer Hello Darrell, You would, of course, replace it if it were cracked and leaking and you would also replace it if the filter is not able to properly depress the valve in it to pass the water at full pressure. Read More...
Art July 18, 2014 for Model Number LFRD2580ST On recommendation of Sears flor employee, I installed Kenmoreclear! Water filter for LG Model LFRD2580ST Refrigerator instead of LG part AP4439984 (filter). Is this Kenmore part truly compatible with my LG model? The dispenser still seems restricted.
1 Answer Hello Art. Some units have a fast fill water system and use a specific water filter designed to work with this unit. If you installed the water filter suggested and it's restricting your water flow, that could be due to it not being compatible. For your unit, we show the water filter is part number 5231JA2006F, thanks! Read More...
David July 06, 2014 for Model Number LG side-by-side refrigerator LSC27931 Water recently started pouring out of my filter cartridge/head unit. The cartridge will turn past locking position. Does this indicate a broken filter head or the water inlet valve? Is this something a novice person can replace? Are there instructions on how to replace both of these units?
1 Answer David, You will first want to pull the filter out and check it to make sure that the filter itself is not busted. If not then the filter head would be the issue. To remove the filter head you would need to pull the unit out and turn off the water. Remove the water valve and disconnect the tubing that goes to the filter. Open the refrigerator door and remove the filter and there will be 1 screw that you remove to take the filter housing out. Pull through the back wall and remove from unit. This will make it easier to change out the head once removed. Read More...
Marc June 22, 2014 for Model Number LFX25960ST I have an LG LFX25960ST refrigerator, the plasic tubing that runs from the supply valve on the bottom up along the rear edge of the fridge through a foam block then into the filter inside the fridge keeps developing small holes and leaking. do you have detailed instructions for replacing it and an LG part number or is it just a generic piece of tubing available at Menards or a hardware store? And, how do you get the tube out of the connectors or do the connectors come with the replacement tube? Thanks, Marc
1 Answer Marc, The part number for the tubing that you need is for the tubing is MJU62070602. To remove the tubing you would need to pull the unit out and turn the water off. Remove the lower cover on back of unit and disconnect the water tube going up to the filter by removing the black blue or red clip below the ring around the tubing. Push on the ring and pull the tube out. You will then need to disconnect the tubing at the top of the refrigerator at the elbow connector the same way. Remove the cover over the tubing and go to the front of the unit and remove the screw holding the filter housing in place. Once removed then you can pull the housing out and remove the tubing the same way that the other tubing was removed. Install new tubing and reassemble. Read More...
Rodney June 09, 2014 for Model Number LFX25980ST I have only a trickle coming from the water dispenser and no ice being made. I have taken the filter unit out (part # 5230JA2003A) and find I cannot blow through it. Now, it may be made that way, but logic tells me I should be able to blow through it? To get flow. Is this my problem? I have also tested the water valve (part # 5221JA2011J) it works but does not produce the intense flow of water that I can get directly from the main wall outlet. Maybe it is designed to restrict the power of the main water supply. Please advise. Thank you
1 Answer Hello Rodney.. No, you can not blow through them. However, if it is old, replace the filter. If the issue continues, replace the water valve on the unit. Read More...