T March 23, 2022 DRYER RUNS BUT NEVER GOES INTO DRY MODE. RUNS AND BLOWS COLD AIR TESTED THERMOSSTAT IS THERE A SWITCH IN THE CONTROLS?
1 Answer T. There is not a switch in the controls that can be reset but would want to test the thermostats and the heater to make sure that they are good. If they are then this will most likely be a faulty main control board. Read More...
John January 21, 2022 for Model Number DV42H5000WA Dryer Runs and does not shut off with no heat.If you power off it continues to run with no countdown.Tried resetting but no luck.Is it the main circuit board that is defective?
1 Answer Hello John, sounds like the motor run relay on the main control DC92-01596D is stuck closed, the repair would be that board being replaced. Read More...
Joshua January 01, 2022 for Model Number dv42h5000ew/a3-04 I got this part number DC92-01606C for a control board from Samsung website. But every site I try to go order it from tells me that it is not the correct board for my dryer model DV42h5000EW/A3-04. Can you help me get the right board most of the boards that comes up has an extra plug in the center of the board that my original does not have.
1 Answer Joshua, the main control DC92-01596D will work with the model number provided. It does not show in our compatibility tool due to revision 04 not being added in as of yet. Read More...
Brian December 21, 2021 for Model Number DV42H5000EW/AE04 On any cycle, if the time is 45 min. It runs for a little, then time jumps down to 2 min could this be the board?
1 Answer Brian, it would be recommended that the sensor bars are thoroughly cleaned to ensure they are not providing incorrect information to the control. From there, the dryer thermistor DC32-00007A would need to be tested for resistance and it should measure around 10K Ohms of resistance at room temperature. If this checks good, the most likely cause of failure would be the main control DC92-01596D. Read More...
Chris October 26, 2021 for Model Number DV42H5000EW/A3 Does this main board match my Samsung Dryer model as shown in this photo https://drive.google.com/file/d/1XNcfOsHD_S5UN4PJdlVkcrkvaefVoeQ6/view?usp=sharing ?
1 Answer Chris,Based on the information provided this would be the correct part number. DC92-01596D Read More...
Kirk April 07, 2021 for Model Number DV42H5000EW/A3-01 When I have the unit on anything but time to dry it runs for 4 minutes and then starts counting down and shuts off like it is a dried load I've replaced the moisture sensors and the thermistor could it be the control board?
1 Answer Kirk, it would be recommended that the dryer blower housing is inspected for a lint build-up and cleared as necessary. If there is not excessive lint trapping the dryer's heat, then the failure would likely be in the main control DC92-01596D. Read More...