Susana July 23, 2018 for Model Number RSG257AAPN/XAA My ice maker stopped working. It will randomly start working only to stop again. Do I need to replace ice maker?
1 Answer Hello Susana, You should first verify the proper operating temperatures are being maintained in the freezer compartment. If the temperatures are getting too high, this will prevent normal operation of the icemaker. Once verified, check the icemaker when it stops for a proper water fill. If properly filled with water, the issue will most likely be the cycling thermostat in the icemaker assembly DA97-07549B. Read More...
Ben B June 18, 2018 for Model Number DA97-07549B Ice maker quit making ice. After going through the reset cycle, the water fill tube only dispenses about one oz of water followed with a ding tone. Afterwards, the ice maker stops making any ice. No moving parts are frozen and the door still produces water on demand. The refrigerator is a Samsung RSG257AARS
1 Answer Ben, With the unit not making ice and the reset button having to be pushed to get it to cycle then this would be an icemaker issue. The part number for the icemaker is DA97-07549B. Read More...
Sean May 01, 2018 for Model Number RSG257ZZBP My ice maker builds up a small amount of ice on the arm, stopping the ice process. When i clear the arm and reset it makes 1-2 bin of ice the drips over and stop arm again. Is it my water valve or ice maker?
1 Answer Hello Sean, This will be caused by the water valve DA97-08587A not filling the icemaker sufficiently. This part will work for model RSG257AABP. Read More...
Jim Sr December 30, 2017 for Model Number Samsung rs265tdwp xaa My ice maker makes ice but in the process it drips water and it freezes a column of ice. This is on the left side of the ice maker. I can usually get about two containers of ice before I have to use a heat gun to defrost the ice maker. I don't know if mine is a 10 or 12 pin? Does it need to be replaced or is there something that could be repaired in this one? Jim
1 Answer Jim, For this issue the icemaker would need to be replaced which will be part number DA97-07549B. Read More...
Dianna April 02, 2017 for Model Number DA97-07549B The ice maker will not dispense ice. Light shuts on and off in freezer. Water dispenses. No noise from auger when we try to dispense ice. Any solution?
1 Answer Hello Dianna. It sounds like the icemaker is bad and will need to be replaced on the unit. Read More...
Michael May 05, 2016 for Model Number RSG257AARS/XAA-0000 I'm replacing the ice maker for this samsung unit, but the heat shield (bottom of unit) screws are not compatible with the replacement unit. Did Samsung change the specs on these screws and if so do you know the size? DA97-07549B
1 Answer Michael, Unfortunately the manufacturer does not not list the screws for the icemaker and unfortunately we do not have the size of them. We do not show a design change on this. Read More...
Chris March 31, 2016 for Model Number RS265TDWP/XAA After an electrical outage, ice maker stopped working. I took it out, let the melted and refrozen ice clear out, cleaned it up, and reinstalled it. Was still not making ice. Manually forced rotator arm through one cycle. This allowed the large arm to float down but still not making ice. Test switch is not doing anything. Anything else to try? Thx.
1 Answer Chris, If the test button did not cycle the icemaker then the icemaker is faulty and would need to be replaced. Read More...
John October 16, 2015 for Model Number DA97-07549B I have a Kenmore Elite with this Samsung Ice Maker. We heard some loud popping coming from the refrigerator and a few days later we had no ice. When I cycle with the test switch, the auger rotates, the ice in the tray melts a little and gets lifted out, then I get a flow of water into the tray. As the auger continues the “ice-full paddle” moves down into the ice bucket, but does not stay down. As the auger rotates into its stationary position, the “ice-full paddle” goes back up into the ice maker. When I opened up the wiring side of the unit, I found a slab of ice inside it. I think somehow a chuck of ice made its way into the wiring box, and the popping we heard was some of the plastic gears being striped as they tried to rotate against the ice. I assume the only solution is an entirely new unit? Thanks
1 Answer Hello John, This sounds like a malfunction of the icemakers' internal components to include the icemaker cycling thermostat and possibly the timing of the internal gears. To correct, it DA97-07549B will need to be replaced. We cannot guarantee this part will work in your unit since we did not have a model number to verify this is the one recommended by the manufacturer. Read More...
Bob S July 24, 2015 for Model Number RSG257AAWP/XAA How do I Remove and Replace the ice maker Part Number AP4450509 ?
1 Answer Hello Bob. Disassemble the Ice-Bucket Assy byholding the handles and pulling up thebottom part slightly. Lift up the Icemaker Cover and gentlypull out. Unscrew the 4 screws and disassemblethe Auger Motor Assy. Disconnect the housing connectors bygently pulling. Unscrew the 3 screws. Disassemble the Ice Maker Assy. Read More...