Joe W August 01, 2012 for Model Number SGM466B When turing on the front center burner, it will spark and light, but the sparker keeps sparking after it lights. What is the cause of this?
1 Answer Hello Joe. Check and make sure there is good grounding on the burner and the burner is clean. If so, you will need to replace the spark module DE81-03927A on the unit it is bad. Read More...
Howard July 06, 2012 for Model Number SGM365R Hello I also need to know how to replace this part. The top on my model doesn't come up.Is it riveted in? I am not certain how to get this part off. Thank you.
1 Answer Hi Howard. Turn off the gas supply and the power. Remove the grates and the burner caps from the cook top. Remove the knobs from the controls. Using a 25/32" (20mm) socket, unscrew and remove the venturi from each of the burner bases and then lift the burner base and rubber O-rings from the maintop. Carefully lift the front of the maintop and prop it up w/ a board or a hammer handle. Unplug the wire from the igniter pin you need to replace. Igniter part # DE81-02696A. Unsnap the e-ring from the igniter body groove and remove the igniter from the cook top. Install the igniter and reinstall the cook top. Thank You. Read More...
Bill W. August 04, 2011 for Model Number ggcw365 When you turn the gas on and it ignites the spark, well not quite on two burners. Can the ignitor be the problem?
1 Answer Hi Bill. Yes, very common that ignitors crack and short out. This part # is DE81-02696A. The burner caps also need to be "cleaned" regurallry with a small brass brush to insure the ground path is correct. Make sure that the burner caps are set back on correctly also. Thank you. Read More...