Andy September 30, 2011 for Model Number KGRA806PSS02 I have the same question; how do you get at this control panel so as to change it?
1 Answer Andy, Heres the information: "1. Unplug range or disconnect power. 2. Turn off gas supply to range. 3. Remove the two grates from the top of the range. 4. Pull the range forward so you can access the two end cap screws. 5. To remove the electronic oven control(EOC) assembly on slide-in models: a) Pull the knobs off the gas valves. b) Remove the two screws from the sides of the end caps. c) Open the oven door and remove the four screws from the bottom of the control panel. d) Pull out on the bottom of the controlpanel, unclip the top edge from the bracket, and rotate the control panel forward so you can access the components. e) Disconnect the wire connectors from the electronic oven control board at P1 and P2, and the ribbon cable connector at P40. f) Remove the four screws from the electronic oven control housing, and remove the assembly from the control panel. NOTE: The EOC boards and the housing are replaced as an assembly. To remove the user interface: a) Remove the electronic oven control assembly (see steps 5 or 6). b) Remove the four machine screws from the control panel mounting brackets, and remove the user interface and its bracket." Thanks and Good Luck Read More...