Bob July 29, 2013 for Model Number RBD275PRQ00 Control panel will not light up at all. Breakers and power check out OK. When pushing start button it beeps but neither oven works. Am I looking at a bad control panel??
1 Answer Hello Bob. It sounds like the control fuse WP4451042 is bad and will need to be replaced. Read More...
1 Answer Hello Ronnie. There is some clips on the control board where the cable attaches. You will press in on these clips and lift the plastic clip upward to release the ribbon cable. Hope this helps. Read More...
Ruben February 28, 2011 My Whirpool Stove/oven model is RBD305PRB00, serial No.: XT3310130. I checked out the drawings, they do not say or show how to pull apart the frame in order to change that switch-memb display. Could you help me with it?
1 Answer Ok, if you remove the side and bottom trim pieces, you should see two screws at the bottom corners of the control panel. Remove these screws and the panel will pull out a little and lift off. From there you should be able to access the panel your wanting to change. Hope this helps. Read More...
1 Answer There are no specific step by step instructions on this repair but if you enter your model number on our website you should be able to see a parts break down. Pay attention to how you take it apart and re-assemble in reverse order. Thanks! Read More...