Barb January 22, 2019 for Model Number KEBC107KSS04 Left light does not work. New bulb does not fix problem. Can I replace the light assembly without pulling the entire oven out. If so, how?
1 Answer Barb, the light assembly WP4448972 will have a screw behind the glass that will hold it in place once it is seated. If you turn off the power to the range and remove the glass, you can remove the glass then the screw. Once you remove the screw, the light assembly should move outwards and then forward from where the screw was set. There should be enough wire length to disconnect the plug for the light from the wire harness. Read More...
Brian Z October 27, 2018 for Model Number Kitchen Aid: KEBS177 Wire connection to one light ( left side) is broken and fixture is cracked, if I get a replacement socket how is it wired? Your answer to a previous similar question states is to pull the old wires from the rear of the unit. Is the wiring for the socket already mounted--I will need to splice the wires since I am unable to remove the oven. If I do splice them can a solderless connection be used if it is also shrouded in some heat resistant material or tape?
1 Answer Brian, The light assembly has the wires already connected to the socket and it is just plug and play. Read More...
Frank July 08, 2015 for Model Number ykebs107db2 How does one replace this part. Specifically how to replace the existing light assembly whose wire runs through the walls of the oven to the back without having to remove the walls of the oven which seems like a very difficult task..
1 Answer Hello Frank. REMOVING THE OVEN LIGHT ASSEMBLY(ONE ON EACH SIDE OF OVEN)Remove the electrical quick disconnect plug from the back. From the inside of the oven cavity unsnap the light lens and light bulb and snap the light assembleout and pull (fish) the wire harness from theback. Read More...
Phoward1 September 28, 2012 for Model Number KDRP487SS03 Bulbs are fine, I am sure it is the latch, how do I check to make sure before I buy the part.
1 Answer Hello Phoward1. If the bulbs are good, the switch can be tested for continuity. It should read closed with the door open. Also, test for 12 Volts coming to the bulb. If it is not there, replace the transformer WP9760587 on the unit. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Phoward1 September 27, 2012 for Model Number KDRP487SSo3 Oven works but the lamp with not stay on when oven is in operation, like it use to, is the latch assembly broken, lamps worked fine then nothing.
1 Answer Hello Phoward1. Check and see if the bulb is bad in the unit. If so, replace the bulb WP4452164. Read More...