Brenda May 13, 2023 for Model Number WFW92HEFU0 What is the name of the hose that goes into the boot seal? Should I replace it?
Cody May 13, 2023 for Model Number WFW9290FBD0 Do I have to remove the front panel in order to get the door boot out?
1 Answer Cody, yes it is recommended to remove the front panel, , it makes it easier to get the bellows off and much easier to install the new one. Read More...
Carl May 13, 2023 for Model Number MHW7000AG2 MODEL#MHW7000AG2. My washer is leaking water around the front door. Would I need to replace the boot and the clamp?
1 Answer Carl apart from using too much soap and causing soap to seep out around the door seal, yes, replacing the door bellow will fix any leaking. Read More...
Pat November 16, 2017 for Model Number WFW92HEFC0 I replaced the bellow on my washer. Now water gathers in the bottom of the bellow. About a inch or so. What could cause this? Thanks in advance
1 Answer Hello Pat. You need to make sure the gasket is positioned properly on the tub. There are drain holes that are suppose to be at the bottom of the gasket to allow that water to drain back into the tub. Read More...
Dw November 29, 2015 for Model Number WFW97HEXL2 I need to replace the liner or rubber boot/seal between the door and the stainless tub. What is the part number and cost?