Customer Questions and Answers for Anti Tip Bracket by Whirlpool

Hello Heather, the safety bracket is designed for the rear bottom of the range to slide into it,so it has to be mounted at the floor/wall corner.

Hello Debi, depending on the unit you might be able to use it. However it's best to use the mounting brackets designed for the unit by the manufacturer. Hope this helps!

Hello Wayne. Unless your model number is already a convection model, you can not add a fan to make it one. The model number will have to be verified on the units I.D. tag since the one listed came up invalid. This will be necessary to look up and specific parts such as the one you requested. Thank you for your patience and understanding in this matter. We will need your model number to help you with this. Please call 1-877-477-7278 or post your model number with a new question on the parts page. Here is a link to help you locate it. http://www.appliancepartspros.com/modelnumber_locator.aspx

Hello Jo, This would not be advisable since the machine will not move if operating properly. You need to check the tub support springs, the shocks, and the tub weights if the unit is properly leveled with the leveling leg lock nuts locked against the bottom of the base. Also, if the washer and dryer are not touching one another and a glass of water on the dryer shows movement, this is motion transferred through the floor. A weak floor is not satisfactory for a front load washer since the apply about 80% more force on the floor than a top load machine does. The machine will have to be moved if the floor cannot be re-enforced in this case.

Mikebradburyw, The part number for the mounting bracket is part number W11759228 for the lower drawer.

Hello Sonja! To verify the correct anti-tip bracket used on your appliance we'll need the model number. Please obtain this information and repost for further assistance. Thank you.

Susan, Only 1 anti tip is required for this unit at install.

Hello Sharon. The bracket WP3801F656-51 is an anti-tip device to keep the unit from tipping over. You bolt it to the floor and slide the rear leg of the range into the bracket. Hope this helps.