Rian September 21, 2022 for Model Number WTW4850XQ1 If the cold works and the hot works, but the warm doesn't, is the problem this inlet valve?
1 Answer Rian, No, if they both work independently then the issue is the control that supplies power to the valve for the warm cycle. Read More...
Troy July 22, 2020 for Model Number MVWC200XW1 The hot water cycle is not working. Hot water line is working and the screen is clean. Could this be the water inlet valve?
1 Answer Troy, it is recommended that the hot water valve is tested for 120VAC during a fill cycle. If there is 120VAC, the valve WPW10356257 has failed and would need to be replaced. Read More...
Tim October 26, 2018 for Model Number 11021302010 I have a Kenmore top washer. What is the part # for the water inlet valve?
1 Answer David, You will want to check to see make sure that the pressure hose is not disconnected from the unit and also will want to check the hoses and tub for cracks or leaks. Also check the water valve to make sure that it is not leaking. Read More...
Ed February 12, 2018 for Model Number WTW4800XQ1 Washing machine sometimes overfills and floods floor or recently stopped and started refilling.
1 Answer Hello Ed. If you can stop the water from entering the machine by turning off the timer or unplugging the unit, you will need to look for a bad pressure hose or replace the pressure switch. If the only way to shut off the water is at the shut off for the water hoses, you will need to replace the water valve in the unit. Read More...
Don October 02, 2014 for Model Number MVWC400XW0 We have water leaking into the tub based on our research it appears to be the inlet valve. After reviewing the parts there are two valves on this machine, should I replace both. The part #'s are W10337065 and W10336721. Thanks
1 Answer Hello Don. You need to remove the hose from the valves and see which is leaking and just replace the one that is bad. You can replace both if you want to. Read More...
Manny August 19, 2014 for Model Number WTW4800XQ2 Water does not fill. Can it be plugged valve were water hoses connect in washing machine? Saw lots of sand when disconnected water hoses from washer.
1 Answer Hello Manny. Yes, try cleaning the screens and if the issue continues, replace the water valve. Read More...
Rob W May 07, 2014 for Model Number MVWC450XW3 Washer makes a hum but will not fill with water. After doing diagnostic found that hot water actuator does not work. Shouldn't it fill on cold even though the hot is not working?
1 Answer Rob, If the unit is set for hot water fill then it will not fill with cold water. The unit may alternate the water supply on warm but should get hot water when the hot is active. Read More...
Denise February 23, 2013 for Model Number wtw4800x00 I'm looking for a water inlet valve for this model washing machine. Confused which one to buy?? Thank you.
1 Answer Denise, I believe the model should read WTW4800XQ0 (Q0 instead of 00). The water inlet valve is part number WPW10356257. Thanks! Read More...