Mark February 01, 2014 for Model Number ghw9100lw1 Ok the circuit boards themselves work fine but the plastic housing has become brittle and one of the button holder that holds the green start button has broken off is it possible to purchase just the plastic housing and then transfer the circuit boards over to the new one. When I was looking for the model # I noticed that mine was different than the ones that you had listed for cross reference (ghw9100lw1
1 Answer Hello Mark. No, you have to order the interface for the plastic housing. Sorry. Read More...
Ken July 13, 2013 for Model Number GHW9150PW0 My washer control nob functioned only on Delicate and Hand Washables. When it was switched to Normal/Casual or Heavy Duty there were no indicating red flashing light, and the estimated time remaining displayed was the same as at Delicate and Hands Washables respectively. Please advise how we can fix this problem. Thanks
1 Answer Ken, This issue would be caused by a bad user interface board which would need to be replaced. Read More...
Neil March 24, 2012 for Model Number gw9100lw2 My Whirlpool washer suddenly stop working. On display it shows dl f. I call u and read repairs tips I ordered door latch. Once I replaced door latch. It shows same thing and makes same noise like cut cut, cut. What should I do.
1 Answer Neil, The "DL" code is an indication of a door lock issue, replacing the latch assembly is a good decision. Did you also check the wiring and connections at the new door latch and the CCU. Did you check the door hinges, front panel and door strike for proper alignment and operation, the latch can operate irratically if the strike doesn't center up in the latch opening on the door panel. If you remove the lower access panel, you should find the Tech Data Sheet over on the left side cabinet wall, and you can conduct the diagnostics and test modes, and have a better idea of what needs you'll have. Thanks and Good Luck Read More...
Darren W. August 28, 2011 for Model Number ghw915opwo Washer gets to rinse and spin cycle and locks up. Timer flashes and controls lock and no error code, door also stays locked. What could be wrong?
1 Answer Hi Darren. The electronic control is part # WP8182785 (user interface). The electronic control board is part # WP8182695. Is the pump clogged and not allowing the high speed spin? Try to clear the pump. Let us know if we can assist furrther. Thank you. Read More...
Mike July 20, 2011 for Model Number GHW9160PW0 I have a Whirlpool Duet washer and dryer. The washer is getting error messages of F11. I clear it out and it starts up again. My question is what part could be the cause of this issue? The CCU or the MCU? I checked all wiring and it still looks new from when we bought it and all connections. Thanks Mike.
1 Answer Hi Mike. The F-11 code is that it lost Serial Communication Error with the CCU or the MCU. If You have checked all connections, then you must have access to your Diagnostic test sheet and follow the steps provided. The User Interface is part # [AP3186174]. Thank you. Read More...
Walter June 19, 2011 for Model Number ?? I have Whirlpool Duet HT and had an error code of f. So I stopped the cycle and when I went to start it back I pushed the start cycle button and it broke and will not start the cycle and to top it off the door is locked and not sure how to get it to unlock??? This looks to be the part (AP3181674) I need, but if I cannot get the door to unlock I will not be able to get to all the screw to take apart.
1 Answer Hello Walter. You will need to remove the toe panel of the machine, and take your hand and pull down on the clip on the bottom of the door lock assembly. This will unlock the door to access the model number to order the correct parts you need. Hope this helps. Read More...