Mike October 04, 2014 for Model Number 11045862400 My washer flashes F11. Everything else checked out with self diag. With the exception f the motor. How do I determine if it`s the motor or the MCU?
1 Answer Mike, The most likely cause for the F11 error will be the motor control or the harness to the motor control but disconnect the wire harness between the motor and the MCU and test for approximately 6 ohms of resistance between terminals 1 to 2, 2 to 3 and 1 to 3. If not then the issue would be with the motor. If this checks ok then the MCU would be the issue. Read More...
1 Answer Hello Carlos. 1. Unplug washer or disconnect power.2. Check wire harness connections to the MCU, the motor, andCentral Control Unit (CCU).3. Check the drive system for any worn or failed components.4. Plug in washer or reconnect power.5. Verify CCU operation by running a Diagnostic test or anycycle.6. Check the MCU by looking for operations of the drive motor.7. Check the drive motor for powered rotations.8. Check that the serial harness at the MCU is not mountedupside down. The wires should be to the left when facing theMCU connectors. Replace the Control WP8182694. Hope this helps. Read More...