Dennis January 28, 2022 for Model Number Gu2500XTPQ6 Dishwasher runs and times down, and then stops at a time and stays at that time for a long time. It will than start counting down again for about ten minutes, than it stops again. Do you think this is a bad control board. Thanks, Dennis
1 Answer Hello Dennis, suggest you run a test cycle first to reset the control board, ,on the dishwasher with door closed press these pads in order, Heated dry ,Normal ,Heated dry Normal, in under 6 seconds, the dishwasher will run a short test cycle, once finished then with dishwasher empty, run just a Normal cycle, do not cancel cycle, let it finish out. If dishwasher still having same problem afterwards then likely the control board (WP8564547) is failing however it is no longer available from the manufacturer. Read More...
Jimmy August 27, 2015 for Model Number GU2548 Dishwasher will not start up. Heated dry light flashing. If you push start normal light will flash or come on and stay on but nothing happens.
1 Answer Hello Jimmy. Based on the information you provided, it sounds like the control panel is bad and will need to be replaced on the unit. Read More...
Andie A. April 08, 2013 for Model Number GU2500XTPQ1 My Whirlpool Gold Quiet Partner III dishwasher is constantly flashing the normal light. I was able to run the diagnostics and reset it once about 4 months ago, but this time it will not reset. So far all the research I have done indicates the control board is bad, am I headed in the right direction?
1 Answer Hello Andie. If the light is flashing, and the unit will not start, that is a sign of a bad control panel WP3385746 on the unit. Read More...
Larry January 27, 2013 for Model Number gu2548xtpq6 My dishwasher quit working period i get a flashing light in the "clean" cycle i try to hit other buttons and start and i get the same thing it flashes 7 times which i've run diagnostic check on it and it seems to be in the heat cycle i've checked each sensor and heater coil and is all within perimeters not to sure with the heater coil i get 10 ohms its suppose to be 10-30 ohms is there a remedy for this like what is exactly wrong with it. PLEASE HELP ME ON THIS. thanks
1 Answer Hello Larry, Since you checked the heater circuit and could not find anything wrong then you would have a faulty heater dirve circuit on the control and would need to replace control board WP8564547. Read More...
Don S July 30, 2012 for Model Number GU2500XTPQ3 Dishwasher was not functioning (possibly due to power surge). Replaced control board and unit seemed to be functioning properly. Just started cycle and light over heated dry is blinking rapidly, unit is not functioning and cannot reset unit. Is the keypad the problem or possibly the heater coil?
1 Answer Don, The blinking LED, indicates a faulty key pad " PROBLEM: WON’T RUN AND LED ABOVE KEY(S) IS FLASHING RAPIDLY . Stuck key(s) or shorted circuit(s) in keypad." WP3385745 Once you replace the control panel, you'll need to reset the control board " To start the ServiceDiagnostics Cycle, press the following keys, in order, in less than 6 seconds, while in standby: Heated Dry, Normal, Heated Dry, Normal"Allow the control to run the complete diagnosis cycle, to off. You should be fine from then on. Thanks Read More...