Veeru April 25, 2020 for Model Number 66516462300 The last run stopped before all water drained. there is little water left at the bottom and none of the buttons working. I have reset the power cord (unplugged, waited for 1 minute and put it back). I had replaced the control panel in last june when some buttons were not working. This time none of them working. what do you think is wrong?
1 Answer Hello, Veeru.Unplug the power cord. Open the control panel and locate the thermal fuse around the control board. Remove the wires from the thermal fuse terminals and check for continuity across these terminals. If there is no continuity, replace the thermal fuse. It comes as a kit and all parts from the kit should be installed. Also, there is a repair video. The part number for the fuse kit 8193762 Read More...
Rick October 30, 2014 for Model Number 66517463000 When I push the control panel button for delayed start all 3 times light up and then when I push start the lights go out. I also can not get the pots and pans button to light up as well as normal wash. When I push the start button the unit works and completes it cycle. Do I need to replace the control panel or is something else needing replacement? Thanks.
1 Answer Hello Rick. yes, you will need to order and replace the control panel on the unit. Read More...
Geebee September 11, 2011 for Model Number 665.16462300 Dishwasher runs only in the pots and pan mode. This light stays on all the time. depressing the cancel button does not stop the cycle. When the wash cycle is complete it will restart by itself. I disconnected the power, pulled the control board out and reinstalled the board. I applied power with the dishwasher door opened and the pot and pan wash button was lit. Once the door was closed the wash cycle started again. How can I determine whether the problem is the control board or the control panel? I might add that the dishwasher for some reason started leaking from the bottom of the door ( too much water ) and I could not get the dishwasher to dump until the cycle was complete ( had to manually remove the excess water ). None of the indicator lights function except the rinse aid light. Thanks in advance for your help. George
1 Answer Hi Geebee. Remove power. From all you discribed, you will need the control panel part # is WP8542351. Thank you. Read More...
Brian August 24, 2011 I installed the new control panel and all the lights work now, but the dishwasher wont start. Do I need a new control board as well?
1 Answer Hello Brian. Check and make sure the door switches WP8269209 are good. If so, you will need to replace the control board WP8564543. Hope this helps. Read More...
Brian August 20, 2011 for Model Number 665.17464300 I was wondering if the followig issues are from a bad control panel. Orginally, the dishwasher wouldn't start and only the Normal wash, high temp wash, sanirinse and air dry buttons would light up. When this would happen the rinse aid empty light would stay on. I then tried to lock the dishwash by holding down the air dry button, but now the lock on will not turn off. Is this the control panel?
1 Answer Hi Brian. Yes, If you cannot control the commands (switching) then you will need control panel part # WP8542351. Thank you. Read More...