Bobby B September 22, 2025 What’s the warranty on this part number? Whirlpool W11165145 Console OEM Part
1 Answer Bobby B, Thanks for the question.Here are links to our warranty and returns pages: Warranty: https://www.appliancepartspros.com/customerservice/warranty.aspx Returns: https://www.appliancepartspros.com/customerservice/returns.aspx and also a link to our customer service team: https://www.appliancepartspros.com/customerservice/ Read More...
Dean August 16, 2023 for Model Number KDTE334GPS0 I was getting error code 9-1 and 2-1 so I replaced the main Controller board part number W11120155 / AP6284984. This fixed the problem for about 2 weeks. Now I am once again not getting a clean LED at the end of a cycle and I am getting error code 2-1 again. All the buttons and LEDs are working fine on the console part number W11165145 / AP6284624. Any idea if this is the main controller board again or if it could be interface console?
1 Answer Dean,Error 2-1 means Control detected stuck key(s) in the keypad or keypad connection. Check the responsiveness of each key. 1. If some keys do not respond: – Unplug the dishwasher or disconnect the power. – Disassemble the door and disconnect the keypadconnection from the control or LCD display module. – Verify all other connections to control are made. – Reassemble the door, but do not close the door (leave the keypad disconnected).– Plug in the dishwasher or reconnect the power. – Wait at least 7 seconds for the control to power up completely. Read More...
Ben March 29, 2023 for Model Number KDTE334GPS0 Hello again, yeah I did all that and was left just scratching my head... The error codes it gave me are 2-1 & 5-2. Neither of which really seem relevant other than 2-1 telling me the it could be either/both the control panel or board.
1 Answer Ben,In the 2-1 error i would follow the steps for unplugging the user interface and waiting to see if the drain does come on. Hopefully, this is not an old error with no meaning to us any longer.You can also clear the error history and run another load to know for sure we don't have old error codes and replace parts that don't need it. Holding a button too long will store that error also. I know young kids like to play with the buttons so maybe clearing codes and another load to be sure is a good idea. If another load is run and no error shows up i would suspect the main control board to be the issue. One last thing to keep in mind. You have a turbidity sensor that is looking for clear water to finish the cycle. When failing they will have long run times but it should throw an error code. Remove the filter in the bottom and on the right side youll see a plastic horseshoe shape piece, make sure its clean and not blocked with debris. Read More...
Ben March 29, 2023 for Model Number KDTE334GPS0 My KDTE334GPS0 started acting a bit funny a few weeks ago. When the wash/dry/sanitize cycle was complete neither the "clean" or "sanitized" light was on as it always had been. A couple days ago I noticed it had been running the wash cycle over and over without ever moving to the dry cycle. I watched it once go from wash to dry then would move back to wash after a few minutes. I reset the breaker which allowed it to run one full wash/dry/sanitize cycle with no lights but then went right back to being stuck in wash mode. I am guessing either the console or main control need to be replaced but both are expensive guesses. The machine is only 3 years old as well. Any suggestions? Thank you,
1 Answer Ben,With the unit behaving this way you should have error codes stored to help you diagnose. Remove the lower kick panel and there is a tech sheet located on the inside of the panel. Follow the instructions to enter service mode and locate the error codes to have a better starting point of checking possible problems. Read More...