Julie June 30, 2021 for Model Number JJW9830DDP I have a Jennair Double Oven that I am having issues with. My top oven gives error and says 1d11 in top corner and will not come on at all. Lower oven comes on but will not get to temperature set to. Both ovens I discovered were doing this in the beginning. Are there any control panels still available for this unit or am i out of luck and will need to replace? Thank You for your help
1 Answer Julie, the error 1d11 is indicating a run-away temperature error. This can be caused by a failed temperature sensor WP74008369 or a failed control WPW10169129. The lower oven issue can be caused by the same parts. The sensor is still available at this time and each one can be tested for resistance and it should measure around 1100 Ohms at room temperature. If the sensors are good, the control has failed which has been discontinued by the manufacturer. Read More...
Jim April 27, 2018 for Model Number JJW9830DDP The electric to my house was off for a couple hours and when it came back on the ovens will not work. The control panel is blank and none of the controls work. The the circuit board is energized but nothing functions. How can I determine if the circuit board is broken before I purchase this expensive board?
1 Answer Jim, Test power to the control board and if there is power to the control board then this will be a faulty main control board. Read More...
Tommy October 25, 2016 for Model Number JJW9830DDP Ovens not achiving temp that is "Set". Set to 475 and will reach 400. Reset the temp to 500 and will heat to 450-490. This is true for both top and bottom ovens. This is true when using "BAKE" or "CONVECT". I've replaced the temp sensors in both ovens. Did not solve the temp problem. Should I replace the processor control board unit?
Jjohn H September 04, 2016 for Model Number JJW9827DDP We have an error code of 1c8c. It happens when we try to clean the top oven. The bottom oven works fine, Would changing the control board fix this problem? Thanks
1 Answer John, Yes the control board would be the part needing to be replaced on your unit for this error code. Read More...
Jarod January 02, 2016 for Model Number jjw9830ddp When we turn the upper oven and try to set the temp manually as we turn the dial the numbers are all over the from high to low as we turn the dial I have to turn very slowly and eventually I am able to dial a temp. the bottom oven dial is fine.
1 Answer Jarod, The issue with the unit would be caused by a faulty rotary bit which is part number 74008488. Read More...
Shari November 23, 2015 for Model Number JJW9827DDP The bottom oven works fine but the upper oven when used instead of convection or regular oven it broils on HIGH, if you turn it on to Broil nothing happens. Does it need as new computer?? I appreciate any advice, Thank you,
1 Answer Hello Shari. Yes, based on the information you provided, it sounds like the control board is bad and will need to be replaced on the unit. Read More...
Lee September 08, 2015 for Model Number JJW9827DDP I am getting a code 4d22 and the lower over shows a fault and won't heat up completely. Would you think the control board is the issue? Everything else seems to work fine. Thanks.
1 Answer Lee, You will want to check the lower oven cooling fan. If the cooling fan is not operating then test for voltage to the fan, if there is voltage replace the fan if not the control board would be the issue. Read More...
1 Answer Hello Ashley. The control board WPW10169129 is a new control board and does come with a warranty. Here is a link to the warranty policy. http://www.appliancepartspros.com/customerservice/warranty.aspx Read More...