Jt March 15, 2011 for Model Number 665.17342300 My soap depenser does not work properly. I was told it may be the board. I replaced mag buzzer. It buzzes to open and continues. Is it the board. Sears told me either or. Help.
Bill March 11, 2011 for Model Number kudr0itjbl0 The board on my unit burned up. I ordered a new board #ap3775964 this board does not match the plugs on my unit. Also the control panel and ribbon is burned up and I can't tell from your break down which one I need.
1 Answer Hello Bill! For the black control panel order WP8270229. This includes the ribbon. The control board ordered WP8564543 is a replacement board and matches your model number. I have located a link on our repair forum that may help with the install process, hope it helps!http://forum.appliancepartspros.com/dishwasher-repair/178582-control-board-connectors.html Read More...
Millard D March 10, 2011 for Model Number kudIL1o1ILbL3 The only thing that works is the cancel button. The lights on the buttons do not light up when I press them. Can you tell me whats wrong?
1 Answer Hello Millard. Try removing the ribbon cable from the control board and cleaning it off. If this does not fix your problem, then you will need a new control board assembly. Hope this helps. Read More...
Warren February 26, 2011 I have a dishwasher model KUDS01DJSS0. The wash cycle has lasted 2 to 3 hours for over a year, so I replaced the control panel. It then ran one time, and then stopped with the "clean" light blinking. I ordered another control panel thinking the first was broken, and it did the same thing. I then replaced the touch panel and replaced the control panel with the most recently received one I have. Even with the new touch panel, the "clean" light blinks 7 times, pauses and then blinks 7 time again, over and over. If I put the original control panel in, the dishwasher works, but it takes the same 2 to 3 hours per cycle. I'm thinking the touch panel has shorted out the control panel, and I'll need another control panel yet now that I have a new touch panel. Any suggestions?
1 Answer Try getting your water hot at the sink before you start a load. That is a fault code for "the water didn't get hot enough". Read More...