Mark February 10, 2013 for Model Number 110.2890270 Can I install a softner dispenser on this model. Mine only has a cap and if so is the part # AP3019975 MFG 63594? Thank you.
1 Answer Hello Mark! Yes, the dispenser WP63594 (63594) can be installed and will work on your Kenmore model 110.2890270. Thanks! Read More...
Sparky November 25, 2012 for Model Number wtw5200sq0 Will this fabric dispenser fit my wirlpool machine wtw5200sq0? Patrs select diagram part # PS334557 is the same agitator that whirlpool has in my machine. Mine came with a removable plastic cap on the top. I am hoping dispenser # 63580 will fit or any one that you suggest? Please advise as asap. Thank you so much.
1 Answer Sparky, yes, the liquid fabric dispenser part number 63580 (63580) will fit your model WTW5200SQ0. Thanks! Read More...
Michele October 13, 2012 for Model Number ETW4300SQ0 I have lost the fabric softener dispenser for my machine. Will this one fit? Thanks!
1 Answer Hello Michele! The dispenser for the listed model is part number 8575076A. Thanks! Read More...
Sara March 29, 2012 for Model Number 11027812692 Hello, The dispenser is releasing softner late in the cycle it seems. Clothes are getting grease spots on them when we use liquid softner. The agitator agitates with no problem while in wash. Any suggestions? My serial number is CG1833465.
1 Answer Hello Sara, As long as the unit is spinning up to speed, this sounds more like a user issue. Give this a try. When you are going to put in the softener, start out with a little less than half of the recommended amount of softener and mix it with hot water to bring the total amount up to the recommended amount. You use hot water to dissolve the softener and a little more than half water to thin the softener. This serves two purposes: It makes the softener mix with the rinse water better and not "cling" to the dispenser and agitator, and it makes the softener rinse out of the clothes better. Remember that the newer the machine, the less water it's designed to use for economic reasons. The less water a machine fills with, the less additives the unit can rinse away. And as an added plus, this will make your softener last longer. At the cost of softener, this will save you quite a bit of money over a years time. Read More...
Pierre Mitchell October 25, 2011 for Model Number ETW4400XQ0 TRIED IT WITH THE CAP OFF IT WOBBLES with the cap on it fits tight when i press down the blue rubber ring seems to be OK this fits over the agitator
1 Answer Pierre, The blue ring is a "snap lock" that secures the dispenser to the agitator. You may want to view the video attached to this part number 63580 it may be more helpful. Thanks and Good Luck Read More...
Pierre M. October 25, 2011 for Model Number ETW4400XQ0 I just received a liquid softener dispenser to put on top of the agitator it does not seem to fit. Do i have to take the top cap off first and should it fit inside the agitator? part number ap3019975 i dont see that number on my shipping list.
1 Answer Hello Pierre. Yes, you will need to remove the cap off the agitator to install the dispenser WP63594. Hope this helps. Read More...