Customer Questions and Answers for Dishwasher Door Spring Assembly With Retainer by Whirlpool

Diane, It is recommended to use the parts as designed by the manufacturer, and this could cause damage and unusual noises as well.

Me, The only data we have on this is a wiring diagram. In situations like this, you should remove the unit and see how the other side is installed and functions and use that as a guide.

Doug, Unfortunately we do not have a photo showing the door spring and retainer on how they are assembled.

Deblyb, Unfortunately we do not have information on how to install the door spring on this model.

Ritchie, The door springs on your dishwasher will hook to the hinges and then down to the frame of the dishwasher. You will need to pull the unit out in order to do this.

Hello Matt, Yes the retaining clip is necessary and it goes on the the lower part of the door spring.

Hello Maximus. • Springs should have enough tension to assist in closing the heavier door. • Door should open evenly, without excessive speed which would cause it to drop abruptly. • Door should remain fully open without closing by itself. 1. If these operation tests are failed and the dishwasher is already installed under the counter, remove the unit from its installed position. 2. Move the lower hook on each of the standard door springs to the farthest adjustment slot to increase spring tension. Repeat the Door Operation Tests. If the operation tests again fail, the heavy duty springs supplied must be used. 3. Close and lock the dishwasher door. Remove a spring from one side by releasing the lower hook from the adjustment slot first, then disengaging the upper hook from the door hinge bracket. 4. Install a heavy duty spring. Insert the smaller hook through the door hinge bracket first, then engage the larger hook in the first notch of the second group of adjustment slots. Open and close the door several times. The door should open and close easily. If the door closes too quickly, decrease the spring tension by moving the lower hook of each spring one (1) notch toward the back of the dishwasher. Springs should be in the same position on the left and right sides. Perform the Door Operation Tests again. Continue to adjust the door spring tension as necessary until the Door Operation Tests confirm proper spring 675611 adjustment. Install the dishwasher in the final installed position by following the installation instructions provided with the unit.

Hello, the retainer end that has a "wiggly" side, will slide into door hinge. Once that is secured, the spring will connect to the round end of it and to the door. Thanks!