Bonapart November 13, 2017 for Model Number A9700 I replaced the siphon break elbow and the end that goes into my original external drain hose is too small compared to the old part. It is about 1/8 inch too small and the hose clamp cannot tighten enough around it. Is this a known compatibility issue with the new part and old hoses? What is the solution? If you suggest I buy a new external drain hose, how sure are you that the new hose diameter matches this part? Thank you
1 Answer Hello Bonapart, There are two listed for the model provided. The difference is determined by the series number of your unit, which is the first two numbers of the serial number. The one you purchased is for the A2 series and above. The one you probably need if for the A0 series 208847 which would fit all units A1 and below. Read More...
1 Answer Gregory, part number WPW10116738 siphon break elbow is not listed for your A183 model. According to your model the replacement is part number 208847. Thanks! Read More...
1 Answer Linda, the outside diameter of the syphon elbow is approximately 5/8 inch, to match the inside diameter of the drain hose. Thanks Read More...
John September 04, 2011 for Model Number lat9635aae How do you install elbow siphon break part #ap4260909?
1 Answer Hello John. You will need to remove the front panel from the washer and remove the screws securing the top and raise the top. Once raised, you will remove the screws securing the siphon break and the elbow WPW10116738 Then remove the old elbow and reinstall with the new elbow in reverse order. Hope this helps. Read More...