Deana October 13, 2013 for Model Number mh7140xfb-0 Does the Black outer door frame, Part Number AP3038817, come with the glass panel?
1 Answer Hello Deana! No, the outer panel 8169353 does not include the door glass 4393725. Thanks! Read More...
Jimmy October 10, 2013 for Model Number RBD275PRB00 The exterior door of the upper wall oven has shattered with no other damage. Can I this be safely replaced and is it available to order? Thanks, Jimmy
1 Answer Hello Jimmy! Yes, the upper oven door glass can be replaced. You'll need to disassemble the door to replace the outer door glass. It is part number 8303320. Thanks! Read More...
Don May 26, 2011 for Model Number whirlpool mh7140xfb-0 In reference to the existing answer on replacing the outer door frame on a Whirlpool Microwave model Mh7140XFB0 I have a couple of questions. Can the vent grill screws and the door posts be accessed while the microwave is installed to the underside of a cabinet? Or do I have to uninstall the microwave and work on it on a table? What exactly is the oven door choke? The choke is not listed on the parts list for the door. Are there plastic clips on this choke that attaches to the outer door frame? Your instructions don’t say how to remove the outer frame from the door which is what I need to do. Clarification on this matter before I order the door frame would be appreciated. Thanks.
1 Answer Hello Don. You should be able to access the screws and door post without an uninstall of the microwave. The choke is the inner door panel edge. Hope this helps. Read More...
Darrell C. April 09, 2011 for Model Number whirlpool mh7140xfb-0 How to assemble the WHIRLPOOL Frame, outer door (black), Part Number: AP3038817 ?
1 Answer Darrell, Here is a general repair instruction manual for the door repair on a Whirlpool microwave door, it should work with little or no changes, 1. Disconnect the electrical supply to the microwave oven. 2. Remove the two screws from the top of the cabinet for the vent grille and remove the grille 3. Open the oven door all the way, then lift the door pins out of the hinge holes and remove it .4. To remove the oven door choke, use a putty knife along the edges, and pry the choke out from around the inside window frame. If needed, 5. To replace the latches and door glass assembly, remove the two mounting screws from the end of the glass frame, then push the top and bottom edges of the door out and unsnap the locking tabs from the frame and remove the assembly. 6. Slide the latches down and remove the hooked tabs from the slots in the door frame, then unhook the ends of the spring from the door, and remove the latches. 7. Reassemble the oven door. 8. Reinstall the oven door and vent grille on the microwave oven. Good Luck and Thanks Read More...