Customer Questions and Answers for Outer Door Frame (Black) by Whirlpool

Susan, unfortunately, the manufacturer has discontinued the outer door frame 8184592 and it is no longer available.

Hello Jason, The manufacturer only supplies the door frame as part of the complete door assembly 8206395.

Bob, To remove the door and replace it, you will remove the air grill. There should also be a corner piece on the door where the hinge is to remove and then you can lift the door off and install the new door. The part number for the door assembly is W10889333.

Greg, unfortunately, the manufacturer does not provide the outer frame separately from the door assembly W10286830.

Don, For this issue the door would need to be replaced and will be part number W10468669.

Hello Kelly, unfortunately the manufacturer has discontinued the door assembly and we no longer have any left in stock. Sorry!

Hello Jessica. The part needed 8169352 has been permanently discontinued by the manufacturer and we don't know of any source or replacement for the part.

Lauren, In order to get the door frame or trim you will need to get the complete door which is part number 8205372. Unfortunately the door has been discontinued by the manufacturer with no suitable replacement available.

Hello! Unfortunately, the manufacturer does not offer the door as an assembled item, only parts to the door are available separately. Sorry about that!

Harry, Here is a general repair instruction information for the door repair on a Whirlpool microwave door, it should work with little or no changes, 1. Disconnect the electrical supply to the microwave oven. 2. Remove the two screws from the top of the cabinet for the vent grille and remove the grille 3. Open the oven door all the way, then lift the door pins out of the hinge holes and remove it .4. To remove the oven door choke, use a putty knife along the edges, and pry the choke out from around the inside window frame. If needed, 5. To replace the latches and door glass assembly, remove the two mounting screws from the end of the glass frame, then push the top and bottom edges of the door out and unsnap the locking tabs from the frame and remove the assembly. 6. Slide the latches down and remove the hooked tabs from the slots in the door frame, then unhook the ends of the spring from the door, and remove the latches, remove the two screws from the door bracket that secure the handle to the front of the door. 7. Reassemble the oven door. 8. Reinstall the oven door and vent grille on the microwave oven.