Robert September 28, 2012 for Model Number 110.88762793 Last night the washing machine stopped working. It will wash and begin the rinse cycle but only for a minute or so. I tried restarting it on different cycle types an still the same thing. As of right now it is sitting full of water.
1 Answer Hello Robert. You will need to check and see if the lid switch WP3355458 is bad and will need to be replaced on the unit. Read More...
Bruno October 05, 2011 for Model Number LSR8233JQ1 My lid switch is broke and I'm missing the 2 screws that attach it. Which lid switch should I get? Do y'all carry the screws that attach it?
1 Answer Hi Bruno. The screw with washer is part # WP3356311. The lid switch is part # 3949247V. Thank You. Read More...
Fix It October 03, 2011 for Model Number LTG6234AW2 How to remove top of washer to replace lid switch ?
1 Answer Hello Fix It. Disconnect the power to the unit. Remove the two screws in the corners of the panel securing the panel. Next unplug the lid switch and remove the two brass colored clips securing the cabinet to the back wall using a flat blade screwdriver to pry them out. Pull on the front of the cabinet and slide the cabinet off the frame of the washer. You can now access and replace the lid switch WP3355458. Reinstall in reverse order. Hope this helps. Read More...
Tony May 09, 2011 for Model Number Whirlpool LTE62234DQ0 Thanks for your answer on removal of the clips. Just to be sure that I got it right, do I stick a screwdriver horizontally under any loop in a clip and yank it up? Or do I try to pry vertically and squeeze the sides of a clip into releasing. I ask this because I don't understand how the clip is really locked in, i.e at the sides or the ends.
1 Answer Hello Tony. You will put the screwdriver inside the hook that is on the right side of the part picture 3349770. This should be inside the cabinet in a cut out. Then you pry toward the back of the washer to release the clips. Hope this helps. Read More...
Tony May 09, 2011 for Model Number Whirlpool LTE62234DQ0 I need to replace the lid switch. I think the washer top comes off from the rest of the washer cabinet? I took off the angled panel below the dryer noticed some clips and 2 screws that seem to hold the washer top. What's the technique for removing the clips, do I lift off or push off?
1 Answer Hello Tony. You will need to use a straight screwdriver and unsnap the clips 3349770 from the washer cabinet to remove the cabinet. Once the clips are removed, the cabinet should pull and slide off the frame. Hope this helps. Read More...
Emil March 26, 2011 for Model Number LTG6234DQ2 I have Whirpool LTG6234DQ2 stackable washer and dryer. The unit is in a closet. I need to replace the lid switch. How do I open the washer side panel and access the switch ?
1 Answer Hello Emil. There is no way to remove the sides, you will need to release the clips and remove the washer cabinet. Hope this helps. Read More...
Gary February 21, 2011 I have stack wash/dry model #Lte6234dq3 will not pump out water /and make a sound or clicking . i disconeted a vac hose and it started to pump water and won"t stop pumping water. whrilpool /timer/switch/pump/lid switch / any help thanks gary
1 Answer Hi, First check the pump and see if anything is in it. Get all the water out of the tub and reconnect the hose you disconnected. Thanks! Read More...