Gerald S. June 15, 2014 for Model Number 11021252110 Need to replace tub bearing I think growling noise only when spinning gets pretty loud. Or am I wrong? Its not a high pitch sound or could it be something else? Greatly appreciate your advice.
1 Answer Gerald, based on the information provided you'll need to replace the gearcase W11454741. Thanks. Read More...
Eldon March 31, 2014 for Model Number WTW4800XQ1 My washer is making a growling noise when it changes to drain & spin cycles and it spins at only about 25% speed. Can you tell me what is wrong?
1 Answer Hello Eldon. You need to lean the washer back and check the large pulley under the bottom of the unit. Most likely the nut has came off and the pulley has dropped down on the unit. If so, use some Loctite on the nut and secure the pulley into place on the unit. Read More...
John February 09, 2014 for Model Number WTW4910XQ0 My washing machine is making a rhythmic clicking noise when it spins. I have removed the inner drum, agitator, and splutch assembly, and when I rotate the spindle by hand, it still makes the clicking noise. Does this mean the transmission is going out? The washer is only 4 years old, and still functions perfectly, other than the clicking noise.
John C February 02, 2014 for Model Number WTW4910XQ0 My washer has developed a clicking noise when the tub spins. The noise is not constant, only when the drum turns past a certain point. I removed the inner tub, and the splutch assembly, and when I turned the driveshaft by hand, it was still making the same noise. Does this mean I need a new transmission? Washer still operates fine in all facets: rinse, drain, spin, etc. The noise however, is getting louder. Thank you.
1 Answer Hello John! Based on the information given you'll need to replace the transmission, part number W11454741. Thanks! Read More...
Billy September 26, 2013 for Model Number wtw4800xq2 My washer seems to tear towels and sheets while washing. After investgation I found the basket is moving 1/4 of a turn more or less while the load is agitating. There are no sharp edges or cracks on the agitator. What do I do to correct the problem? Thanks, Billy
1 Answer Hello Billy, The tub is not supposed to move during agitation. This would be a problem with the splotch or cam kit W10721967. Read More...