Michael R. January 01, 2023 for Model Number KBFS25EVWH1 One of my pantry rails came apart. Is it possible to slide the inner rail back in? Thanks
1 Answer Hello Michael, The metal rails can be reinserted into the plastic rails unless damaged or broken. Read More...
Dan November 18, 2017 for Model Number WP67007026 Is there a difference between left or right door glides for part# WP67007026. When researching the part I have seen this called out but your website did not. Is there a difference?
1 Answer Dan, For the glide WPW10235370 there would not be a difference between the left and right. Read More...
Paul June 22, 2016 for Model Number MFI2568AES If I order part no AP6010541 does it include the left and right side slides?
Bob January 28, 2016 for Model Number AFI2538AES4 Part #AP4082127, is there a left and right or both the same.
Amateur May 24, 2013 I had bought a glide (part AP4082127) to replace a maytag part (13058101V) and it separated upon install. How do I put it back together? The "outside" part seems to get stuck every way that I try to put it back together. Do I need to disconnect that part that is bolted to the refrigerator? Is it possible to put it back The glide has two parts that slide against one another with a ball-bearing fixture. Pulling against the one part caused the outside part to become removed from the part bolted to the fridge Nothing seems bent, etc. But, I can't figure out how to get the outside piece back on. Every time I try to put it back on, it gets "stuck"
1 Answer Amateur, If you are unable to get the pantry glide back together then you would need to get another glide. Read More...
Linda S April 04, 2012 for Model Number Whirlpool pantry glide part number 67007026 I am an older woman .how do I install the pantry glide on the right side? I shut the door on the other one and it popped off so I now have the replacement not sure how to slide it on correctly
1 Answer Linda, You forgot to include a model number of your fridge, but, Of course you'll need to remove the bin/drawer. and removing the top glass shelf helps a lot also. You'll need to leave the glide extensions out as far as possible and, depending on your version of refrigerator, you will find at least one phillips head screw holding the rail to the drawer end cap and there may be a white plastic tab sticking through the metal rail at the back, you'll need to press in on the tab and slide the metal rail out of the retainers. The other version will have two phillips head screws, the procedure is the same, either way. Thnks and Good Luck Read More...