Pj February 14, 2017 for Model Number MDG3000AW Dryer will not start; burnt smell. was loud noisy for a while. Want guide to diagnose what could be wrong
2 Answers PL, the information would indicate you most likely have burnt out motor. You will need to disconnect power to the machine. Remove the front panel and door. Remove the front tumbler support.shroud assembly. Remove the belt and tumbler. Remove the screw in the front of the blower cover that holds the cover to the base of the machine. Remove remaining screws from the front blower housing and remove cover. Remove retaining clip and snap ring from motor shaft and remove blower wheel. Label or mark wires and disconnect wires from motor switch. Remove the motor support clips which retain the motor to the motor base. Use a nutdriver large enough to accept the hook end of the clip. With a downward push of the nutdriver onto the clip end, tilt the nutdriver handle toward the motor to unhook the clip from the support. Remove the motor. Reverse the procedure to install the replacement motor. Read More...
Pj February 14, 2017 for Model Number MDG3000AW Dryer will not start; burnt smell. was loud noisy for a while. Want guide to diagnose what could be wrong
2 Answers PJ, In order to send out information on this we would need to have an email address to send it to. Read More...
Raymond July 09, 2016 My washer is Samsung 4.2cu front loader . The small door part that allows it to latch ( pastic ) is broken. How do I get that part?
2 Answers Hello Raymond. We will need your model number to help you with this. Please call 1-877-477-7278 or post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...
Raymond July 09, 2016 My washer is Samsung 4.2cu front loader . The small door part that allows it to latch ( pastic ) is broken. How do I get that part?
2 Answers Hello Raymond, I'm sorry but we will need you to post a new question with the model number from the units' I.D. tag so we can give you part numbers that will work for your unt. Thank you for your patience and understanding in this matter. Read More...
Lena August 29, 2013 for Model Number 3363394 How much does it cost to replace the springs on a whirlpool washer? My machine seems to be lose and it is very noisy.
1 Answer Hello Lena. It depends on the model number of the unit. We will need your model number to help you with this. Please post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...