Customer Questions and Answers for Lid Hinge by Whirlpool

Agustin, You will want to tip the unit back and check the thrust bearing. When turned one way the thrust bearing will spin without lifting. The other way it is supposed to lift the brake assembly. If it is not lifting the brake then the thrust bearing is bad and would need to be replaced.

Jason, the female lid hinge WP35-2044 comes one per package. For the matching male lid hinge order part number WP35-2045. Thanks.

Hello Robert, it should be lid hinge pin WP35-2045. Thanks!

Hello, Glue will definitely not hold on a lid hinge. If you had posted a model number, I would have looked up the part number for you.

Hello Richard. You will use a flat blade putty or butter knife and press in on the clips WP25-7220 to release them and raise the top assembly of the washer.

Hello Judy. You will need to raise the top of the washer to access the hinges and replace them. Release the clips from under the top panel and lift the top up. Then access the screws for the hinges. Remove the screws and replace the hinges WP35-2044. Hope this helps.