Richard August 12, 2016 for Model Number MAH3000AWW Machine will no longer run at all. Found the fuse, that is soldered onto the drive board, blown. Is there a way to check the motor to see if it is bad or could it be just the drive board? Also, does the motor and drive board have to be replaced at the same time?
1 Answer Hello Richard. Yes, you will need to order and replace the complete kit 12002039 to repair the unit. Read More...
Robert November 08, 2013 for Model Number Maytag Neptune MAH6500AWW The machine works well when in wash mode. You can hardly hear it run. However, when its spinning, it sounds like a piper aircraft engine. very annoying. There is no noticable shake when it is spinning . do you have a suggestion.
1 Answer Hello Robert, 22004465 will most likely need to be replaced since this is the characteristic of a bad spin bearing. Be aware that the part cost will be wasted if the spinner support assembly W10181639 has wear markings on it and it is not replaced at the same time. These wear marks will cause the new seal and bearing to fail prematurely. Read More...