Alton May 11, 2023 Sometimes the lid of my washer unlocks and sometimes I have to jiggle it before it will open. I think it there may be buildup on it. How can I clean it?
1 Answer Alton, aside from using a q-tip to clean what is accessible without disassembling the latch itself, the latch would need to be replaced as it is not designed to be taken apart. Read More...
Darrell May 11, 2023 for Model Number 110.2992310 Washer has power but won't start. Door lock clicks but you're able to pull the door open. How do I ohm out this type of door lock and how can I get tech sheet?
1 Answer Darrell, the tech sheet is oftentimes found on the front panel under the lid or in the control panel. The lid lock solenoid can be tested from the main control from connection J15 pin 1 to pin 3. It should measure between 85 to 155 Ohms. Read More...
Barbara May 11, 2023 for Model Number MVWP575GW0 Need to replace the latch. I don't see repair video. How do I change it out? Thanks
1 Answer Barbara, the following link has a repair video that can be used as a reference for changing out the latch. https://www.appliancepartspros.com/whirlpool-bezel-lid-lock-wpw10392041-ap6020796.html#autoplay Read More...
Luke July 26, 2019 for Model Number CAE2795FQ0 the washer don't turn on. there is power on the outlet but the washer will not turn on.
1 Answer Hello Luke, your washer comes with a tech sheet giving showing all testing and wiring, its in a plastic envelope attached behind the front cabinet neat top. Remove the rear control panel cover and see itf there is a green light glowing on the back of the control board, if not, disconnect all the wire harnesses from the board one by one leaving the J7, if still no display then likely the control board has failed. Read More...