Robert December 04, 2018 for Model Number SLW330RAW I replaced the Brake clutch six months ago, washer was working fine, then the belt broke, so i put on a new one, washing in wash cycle sounded like the brake were dragging causing the belt to slip and burn up.In the spin cycle i can see the brake clutch release and spin free then stop like normal. Would the bearing in the MilkStool be worn out allowing the tub, transmission to drop and bind up the wash cycles. tHAK YOU.
1 Answer Robert, The brakes would stay engaged during the wash cycle and would not cause the belt to slip. Also if the bearings are bad then the it would be making a loud noise during the spin cycle. The transmission dropping could cause this issue where the shaft of the transmission is dropping down and the transmission would need to be replaced for this. Read More...
Fred December 27, 2012 for Model Number Maytag SAV515DAWW The tub in my maytag has dropped about 3 inches inside the machine, It washes ok, but when the spin cycle comes on the tub seems to hit against the inside and the machine knocks bangs and actually turns itself around. Now, the clothes are still soaking wet after it stops. The floor under the machine is also wet and oily. Can I repair the machine myself, and what parts would I need. Thanks
1 Answer Hello Fred, Yes you can repair the unit yourself. The parts that you are looking at a minimum of is the hub and seal kit W10116790, transmission W10840857, check the outer tub for damage 40111001P, possible brake R9900474 R0000014 issue from oil. Read More...
Dane August 24, 2012 for Model Number sav5910eww This part is a replacement for the original? Has it been updated?
1 Answer Hello Dane. Yes, this milk stool 12002013 is the correct replacement and has been updated. Read More...
Cecil D. October 06, 2011 for Model Number sav5910aww Does the milk stool part # ap4009520 come with a bearing and if it does is it the upper/lower bearing part # ap4047999?
1 Answer Hello Cecil. Yes, the milk stool 12002013 comes with the bearing. It is the upper/lower bearing WP40004001. Hope this helps. Read More...