Skip to Content
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Trusted Since 1999 Trusted Since 1999
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google

Customer Questions and Answers for Oven Temperature Sensor by Whirlpool

Best Seller
Manufacturer Part
4.89 (64)
By: Whirlpool
Part Number: OEM12027036
Manufacturer Part Number: 12001656

Fix F1 error codes and temperature control issues with this oven temperature sensor. Takes about 15 minutes to install—just 2 screws and plug-in wiring.

More
$42.95

IN STOCK
Ships Tomorrow Guaranteed
Add to Cart

Questions & Answers

For Whirlpool Oven Temperature Sensor (Part Number: OEM12027036)

1 Answer

Dennis,

It is possible that the oven sensor as it gets hot it will give a false reading but you will want to check to make sure that there is no damage to the wiring. If the preheat light is coming on after it gets to 325 then it does sound like a bad control board.

Read More...

1 Answer

Hello Susan. If you can see the screws inside the oven, you can replace it from there. If not, you will need to replace it from the back of the unit.

Read More...

1 Answer

Hello Gary. If the sensor is new, you will need to order and replace the control in the unit.

Read More...

1 Answer

John,

The sensor could cause the unit to turn the fan off before it completely cools. What you want to check is at the control board check the oven sensor from this point to check to make sure the sensor is good. The ohm reading at room temperature should be approximately 1090 ohms.

Read More...

1 Answer

Fred, The F4 error code indicates a shorted oven temp. probe 12001656, a damaged wire harness, or fault in the ERC/Clock. The sensor resistance should read 1050 to 1100 ohms resistance at room temp. If the sensor tests proper and theres no obvious visible damage to the harness between the sensor and ERC/Clock, then you'll need the ERC/Clock.

Read More...

1 Answer

Connie,

You will want to check the oven sensor for resistance. The resistance value should be approximately 1090 ohms at room temp. If not then the part needs to be replaced.

Read More...

1 Answer

Ned,

You will want to make sure that both elements are coming on during the preheat cycle. If the broil element does not have voltage out at the control board then you would need a new control. If 240 vac is present with unit turned on the bake cycle then replace the broil element.

Read More...

1 Answer

Mike,

You can pull the unit out and access the back of the unit to disconnect the oven sensor. This is the best way to do it because you will have to push the new sensor wire in past the insulation.

Read More...

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro
Or ask a question by filling in the form

Share your thoughts with other customers

Ask a Question
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google