Pete April 04, 2015 for Model Number ALG443RAW On the original dryer glides the felt pad was glued on to the dry glide. Your video instructs to glue the felt pad on the metal bracket. Which is better. The last time I replaced them I copied the way it was from the factory. One of the pads came off and the drum wore the bracket clean through. Do I put the felt on the dryer glide as it was installed by the factory or should I put it on the metal brackets?????
1 Answer Pete, Install the felt pad on the metal bracket, as centered as possible, then install the glide on top /over the pad, just like the video attached to the part diagram. Read More...
Greg October 22, 2013 for Model Number mde4806ayw This felt pad, 500121, goes between the dryer glide and the support. The felt pad has a piece of paper attached to it. Should that paper be removed? If the paper is left attached, which surface of the felt pad should be adjacent to the dryer glide? Thanks
1 Answer Hello Greg. Remove the paper and stick the pad to the support bracket on the unit. Read More...
Sam October 06, 2012 for Model Number mdet236ayw Does this felt go between the bracket and the glide, or on top of the glide and the drum actually rides on this felt pad?
1 Answer Hello Sam, The felt pad goes under the glide. This means that the drum rides on the glide, but the felt is there to prevent any metal to metal contact. Read More...
Dan September 04, 2011 for Model Number ALG643RBW Where does this felt pad go? Underneath, next to, or on top of the Drum Dryer Guide?? What is it for? (The Drum Dryer Guides support the Drum and allow it to turn with minimal friction.)
1 Answer Dan, The front felt guide WP500121 , is installed under the front drum glide WP37001298 , between the silicone glide and the metal of the bulkhead. You may want to use a dab of "contact cement" to help hold it in place( some people do). Good Luck and Thanks Read More...