Skip to Content
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Trusted Since 1999 Trusted Since 1999
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google

Customer Questions and Answers for Pulley- Mo by Whirlpool

Best Seller
Manufacturer Part
4.89 (64)
By: Whirlpool
Part Number: OEM18029580
Manufacturer Part Number: WP6-3051850

Questions & Answers

For Whirlpool Pulley- Mo (Part Number: OEM18029580)

1 Answer

Hello Rodney, there is a pulley WP6-3051850 on your motor but, the idler pulley WP6-3037050 is more likely to fail than the motor pulley. Also, on the other end of the motor, you should check the blower wheel Y303836. While you're in there, take a look at the drum support rollers 12001541 and drum glides 306508. That is most of the likely noise makers in a dryer. Hope this helps!

Read More...

1 Answer

Hi Ken. The bottom bolt uses a guide washer that goes into the hole with the screw is the only mount screw needed. You did not find anything loose in the base pan did you? The belt tensioner pully is pulled taught from the mount to the base with a spring. Hope this helps. Thank you.

Read More...

1 Answer

Kenneth, First check the blower wheel Y303836 quite often, after a few years of wear and tear, the wheel has a tendency to " round out " and the motor shaft spins inside the blower wheel hub and makes noise. If you grasp and twist the wheel back and forth, there should be very little to no play at all between the hub and motor shaft. Thanks and Good Luck.

Read More...

1 Answer

Hello Eddie. You will need to check the idler pulley wheel WP6-3037050, and see if the pulley is worn. If so, you will need to replace the pulley. Hope this helps.

Read More...
Rita for Model Number LDE 7334 ACM

My maytag dryer was purchased in 1998. When you push the start button the dryer start up making a strange noise. Then as it is running, the sound it is making comes from the back of the dryer where the motor is located. It sounds like there is a flat spot, roaring noice at intervals. The when you open the dryer door, it makes a different noise as it is shutting down, like a rubbing noise or dragging noise before it comes to a complete stop. We had the dryer apart and checked the blower wheel. There was no play in the wheel where it slides on to the motor shaft. The roller bearings spinned freely. The idler pulley and drum slides and belt looked O.K. Could the bearings in the motor be going bad. Do I need to replace the motor?

1 Answer

Hello Rita. Try turning the blower wheel by hand and see if the drum turns with it, or if just the blower wheel turns. If it is just the blower wheel that turns, you will need to replace the blower wheel Y303836. Hope this helps.

Read More...

1 Answer

Hello Mari! We will need the to know what type of noise and which part of the dryer it is coming from in order for us to help you diagnose and advise what parts should be replaced. Thanks.

Read More...

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro
Or ask a question by filling in the form

Share your thoughts with other customers

Ask a Question
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google