Anthony June 19, 2019 for Model Number Kitchenaid Professional 6000 - I have purchased three different snap ring pliers. I cannot remove these Retaining Clips. What is the size of the tool you are using to remove these snap rings?
1 Answer Hello Anthony, Any set of external snap ring pliers should remove this snap ring. It just has to be expanded to remove it from the groove. Thank you for your patience and understanding in this matter. Read More...
Keyur October 24, 2016 How to remove this retaining clip? Is there any special tool? I am unable to open it.
1 Answer Hello Keyur. Yes, you will need to go to your local hardware store and purchase a retaining ring tool to remove this clip. Read More...
Linda May 19, 2014 Can you please advise the tip size for the snap ring plier? I have a 0.06 inch tip. But it cannot fit the snap ring. Thank you
1 Answer Hello Linda! Unfortunately, we do not have the size information available. Sorry about that! Read More...
Loneranger February 18, 2012 for Model Number KP2671XGR I have a KP2671XGR that has the main shaft lose. I mean that as it rotates the assembly is about to come off making a horendouos noise. I bump it up until I my wife is able to finish the task. Could it be this retining ring. Can I get a service manual to replace this and other parts?
1 Answer LoneRanger, Yes, there is a retainer ring WP9703438 that holds the shaft up and into the drive gears. Check your email for some basic information and help. Thanks and Good Luck Read More...
Erica February 19, 2011 I am trying to remove a retaining clip like shown above part number AP3038086. How do I do this? Is there a special tool? Thanks.
1 Answer Erica, they are typically called a snap ring and you can buy a snap ring tool at any hardware store. Thanks. Read More...