Bob April 11, 2012 for Model Number du960pwkb1 Does the new bearing ring that goes under the bottom spray arm come with a nylon wear band? Thank You.
1 Answer Hello Bob. No the bearing ring WP3376846 does not come with the nylon ring WP9742946. Hope thsi helps. Read More...
Ron January 06, 2012 for Model Number DUL200PKT1 I see that there is supposed to be some play in the lower control arm. I have almost a quarter inch of clearance between the top washer and the retaining nut. Is this much normal. I have developed a leak coming from the front door area. I have replaced the door seal. The leak seems to be occuring because water is shooting up through the vents at the bottom of the inner door panel. Any ideas?
1 Answer Hi Ron. This tell me that the lower bearing ring under the wash arm is worn out, it is part # WP3376846. The upper ring under the top cap is part # WP9742946 in case it is worn also. Thank You. Read More...
Repeat Customer November 14, 2011 for Model Number Whirlpool Portable dishwasher with block top Has a screeching sound when draining. Drains fine and washes fine. I also have a problem with main soap compartment no longer opens and I don't think my rinse aid coompartment works either.
1 Answer Repeat, We really need a model number to properly assist you, there are hundreds of W/P portable dishwashers, and They have several wash and drain pump variations, as well as detergent/rinse aid dispensers. The squealing noise could be something in the pump or a bad bearing. The detergent dispenser issue could be due to a broken spring, defective bi metal switch or wax motor. Thanks Read More...
T.S. November 02, 2011 for Model Number 8268845 and 8519604 Needing to replace the plastic rod that connects these two parts together, but unable to locate a model number.
1 Answer Hello T.S. The bearing ring WP3376846 is used in the middle spray arm and supply tube kit 675808. It is also used under the lower spray arm and is held in with the spray arm and the restrainer nut WP9742945. Hope this helps. Read More...
Charles B. July 15, 2011 for Model Number DU945PWPQ2 The upper spray arm on our dishwasher does not spin and leaks at the bearing ring.is this leak enough to cause the arm not to spin or should I be looking elsewhere for the lack of water pressure.
1 Answer Hi Charles. Does the back cone area of the spray arm feed tube hold tight against the water manifold? Yes this bearing ring should allow the spray arm to spin. It Is Part #WP3376846. Check your spray arm jets to see if they are clogged. If so then remove the arm and use a pick tool to unclog them and rinse them out backwards under the sink. Thank you. Read More...
Jan W. June 20, 2011 Old dishwasher and cannot find model #. I found the AP3044851 bearing ring loose in the bottom of the dishwasher and replaced it. My question - is the spray arm supposed to be loose, as in kinda floppy up/down movement? If not, then I may have another part missing? Thank you.
1 Answer Hello Jan! Yes, it is normal for the lower spray arm to have some play in it. This allows the arm to turn freely. Thanks! Read More...
1 Answer Hi, WP3376846 is the bearing for the spray arm and it is located at the bottom of it. Thank you. Read More...